User manual REMINGTON HC5600

[. . . ] 5mm Stubble comb (HC5600) AE 3 HR SL GR RO TR 9 RU HUN PL 11 12 CZ SK FIN S DK I E F NL D ENGLISH C GETTING STARTED , CHARGING YOUR APPLIANCE • Before using your hairclipper for the first time, charge for 16-20 hours. € Connect the charging adaptor to the product and then to the mains. € If the product is not going to be used for an extended period time (2 – 3 months), unplug it from the mains and store. € To preserve the life of your batteries, let them run out every 6 months then recharge for 16-20 hours. [. . . ] , STEP 2 – Back of the head • With the comb set at 12mm or 18mm, cut the hair at the back of the head. , STEP 3 – Side of the head • Set the comb to 3mm or 6mm, trim sideburns. Then change the setting to 9mm and continue to cut the top of the head. , STEP 4 – Top of the head • Use the longer length comb attachment and set it to 24mm or 27mm then cut hair on top of the head against the direction in which the hair normally grows. € For longer hair on top, use the longer length comb attachment (24 – 42mm) to achieve the desired style. , STEP 5 – The finishing touches • Use the clipper without an attachment comb for close trimming around the base and sides of the neck. € To produce a clean straight line at the sideburns, reverse the hair clipper. Place the reversed clipper at right angles to the head, tips of the blades lightly touching the skin and then work downwards. 6 ENGLISH GB , SHORT TAPERED STYLES – “FLAT TOPS” & SHORT CUTS • Starting with the longest guide comb attached (24 - 42mm), cut from the back of the neck to the crown. Hold the guide comb flat against the head and slowly move the clipper through the hair. € Use the same procedure from the lower side to the upper side of the head. Then cut the hair against the direction in which it grows and level with the sides. € To give a “flat top” look, the hair on top of the head must be cut over the top of a flat comb. € Use a closer guide comb to taper the hair down to the neckline as desired. , DUAL BOOST SYSTEM (HC5600) • There are 3 settings for the Dual Boost system: Off, On, Boost. • If the clipper is set to boost , it will provide maximum power. , AUTO BOOST SYSTEM (HC5800) • There are 3 settings for the Auto Boost system: Off, Auto, Boost • If the Clipper is set to Auto, it will run at regular power under low load conditions. € When more power is needed, the clipper will automatically sense this and provide maximum boost. € To activate the Boost setting, depress the power button for 2 seconds. c CARE FOR YOUR HAIRCLIPPER Your clipper is fitted with high quality blades. To ensure long lasting performance of your clipper, clean the blades and unit regularly. , AFTER EACH USE • Ensure the clipper is switched off and disconnected from the mains before cleaning. [. . . ] € Ensure that the clipper is discharged of all power and disconnected from the mains. € Using a small screwdriver, remove (1) screw from the bottom of the clipper. € Pry the front panel from the front housing and expose the inner housing . € Using a small screwdriver, remove (4) screws from inner housing • Pry the cover of inner housing and expose the PCB and batteries. [. . . ]