User manual REMINGTON I LIGHT IPL6750

[. . . ] A replacement can be obtained via our International Service Centres. 9 Do not twist or kink the cable and don?t wrap it around the appliance. Do not put the appliance in liquid; do not use it near water in a bath tub, basin or other vessel; and don?t use it outdoors. Do not reach for your unit if it has fallen into water - immediately unplug it from the electrical outlet. [. . . ] , Skin Contact Sensors ? This safety mechanism prevents accidental flashing. The device will not flash unless both Skin Contact Sensors are in full contact with the skin. 9 SK P FIN S DK I E F NL D ENGLISH , Flash Button ? The Flash Button is located on the hand piece. body Attachment Facial Attachment Bikini Attachment 10 ENGLISH GB Fig. 4 , PREPARE YOUR SKIN FOR TREATMENT ? Ensure the area to be treated is clean and free from oils, deodorants, perfume, make up, lotions and creams. Shave the hair from the area to be treated, and ensure the skin is clean and dry. ? Never use wax, epilation, tweezers or other methods that remove the hair from the root as IPL is not effective if the hair has been pulled out. 11 SK P FIN , CHECK YOUR SKIN TONE ? Consult the skin and hair chart at the front of this manual to ensure your skin is in the suitable range and your hair colour is susceptible to treatment with i-LIGHT. ? Place the skin of your intended treatment area onto the skin sensor ?, NOTE: You must use the skin sensor on each body part you wish to treat. S DK I E F NL , Attachment Release Buttons ? Press both buttons and gently pull to remove the attachment. please be sure to read the Warnings and Safety Precautions carefully before beginning a facial treatment. , IMPORTANT: The Facial Attachment has been specially designed to treat the unique characteristics of female facial hair. 14 ENGLISH GB C TREATMENT TIPS , Body Treatment ? For best results , avoid overlapping flashes. This helps prevent exposure to more energy than is necessary to suppress hair growth. ? For the most effective results, always use the highest intensity level that does not cause discomfort on the skin. The level you use should feel warm on your skin, but should never cause discomfort. ? You may notice that bony areas, such as elbows, shins and ankles, are more sensitive during treatment. To avoid this sensitivity, try stretching the skin away from the bony area during treatment. since facial skin tends to be more sensitive, make sure you test on a small patch before proceeding. using a mirror for a good view of the area to be treated and to help ensure you avoid treating the lips or any other dark spots. If the reflected light is unpleasant, you may want to close your eyes before each flash. [. . . ] ? Try resetting the unit by turning it off and waiting several seconds before turning it back on. , BE AWARE: If the unit is used over an extended period of time, the unit might automatically disable momentarily (estimated 40 seconds) to cool down. Flash button was pressed while the skin contact sensor was not fully engaged. Flash button was pressed after the skin contact sensor had been engaged since unit start up. [. . . ]