User manual REMINGTON R-9500

[. . . ] Except when charging, always unplug this appliance from the electrical outlet immediately after using. Do not use an extension cord or a voltage converter with this appliance. To disconnect, turn all controls to OFF, then remove plug from outlet. Do not use this appliance with a damaged or broken screen or cutters, as injury may occur. [. . . ] Your Smart Shaver can also be recharged by plugging it into the cord directly. Connect the cord to the shaver, then plug the charging adapter into the electrical outlet. Your shaver cannot be overcharged, so you can leave it plugged in and charging between shaves. To preserve the life of the batteries, let them fully run out every six months, then recharge them for a full 24 hours. Cord/cordless rechargeable shavers can run directly off the cord if necessary. They will not recharge while you are shaving, so after shaving with the cord, turn the unit off and set it aside to charge. Cord/cordless shavers should not be used strictly as cord-operated shavers, as continued cord-only use will result in reduction of battery life. Quick Charge provides up to three weeks of shaving after a one-hour charge, or a single shave after a five-minutes charge. NOTE: If your shaver battery is completely discharged or the shaver has not been used for a long time, the shaver may not start when operated using the cord. If this happens, charge the shaver for approximately five minutes before shaving. You will need to keep the buttons pressed in as you move the upper portion away from the base. Pour the bottle of cleaning solution into the base of the unit through the opening where the filter was removed. Plug the power cord into the cleaning base and then into an electrical outlet. Place the shaver into the unit, head side down, and slide its "tail" toward the "neck" of the base until it clicks into place. Charging Your shaver automatically begins to recharge as soon as it clicks into place in the cleaning base. While it is charging, the green indicator light will flash; when it is fully charged the green light will stop blinking and glow steadily. cleaning To activate cleaning mode , simply press the CLEAN button on the cleaning base. The amber indicator light flashes through the entire cleaning cycle, which lasts approximately 25 minutes. When the cleaning cycle has been completed, the amber light will stop blinking and glow steadily. The filter collects hair clippings and debris, and should be replaced along with the solution. Replace the top portion of the cleaning base by lining up the three tall posts with the three holes in the tank. Wait until the cleaning cycle has finished Before removing the shaver from the base. [. . . ] Pulling When the cutters wear you may feel a sense of pulling and a loss of closeness when you shave. This is an indication that it is time to replace your heads and cutters. We will return your product, shipping charges prepaid, if you do the following within two years of the purchase date: 1. Return the complete product in person or by mail, postage paid, to a Remington Company-owned Service Center or Authorized Service Dealer. [. . . ]