User manual ROCKTRON RB60

[. . . ] Clean with dry cloth Copyright © 2003 GHS Corporation All Rights Reserved. Precautions Continued. . . . Do not block any ventilation openings (if applicable). Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. This pedal runs on a 9 Volt Battery, if a 9Volt DC adapter is the used please follow adapter manufacturer's operation instructions. [. . . ] This pedal runs on a 9 Volt Battery, if a 9Volt DC adapter is the used please follow adapter manufacturer's operation instructions. Do not use this product with any case, stand tripod, bracket or table that is not specified by the manufacturer. Unplug this apparatus during lightening storms or when unused during long periods of time. Servicing is required when the apparatus has been damaged in any way, such as power supply or plug is damaged, liquid has been spilled or objects have fallen into the apparatus or if the apparatus has been exposed to rain or moisture, does not operate normally or has been dropped. DO NOT MAKE ANY INTERNAL ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT AT ANY TIME OR TAMPER WITH INTERNAL ELECTRONIC COMPONENTS AT ANY TIME. FAILURE TO FOLLOW THESE INSTRUCTIONS MAY VOID THE WARRANTY OF THIS EQUIPMENT AS WELL AS CAUSING A SHOCK HAZARD. This unit is designed to operate between 32 F and 104 F (0 C and 40 C). This unit may not function properly under extreme temperatures. Introduction Congratulations on your purchase of the Rocktron Short Timer Retro Digital Delay Pedal. The actual delay time is then adjusted using the "Time" control (see point 4) 2 3 4 5 Bottom Left Side Right Side 6 Output Jack - Using a standard guitar cable with a 1/4" jack, plug into the input of your guitar amplifier or next stomp box Input - Using a standard guitar cable with a 1/4" jack, plug the output of your distortion pedal or your guitar into this jack. If using in an effects loop plug the cable from the "send jack" on the amp or effects unit to this jack. On/Off Switch - This switch determines whether the pedal is "active" or "bypassed" - When "active" the blue LED will be lit. DC 9V Input - To use external power (not provided) use only a 9-Volt DC adapter 9-Volt Battery Compartment - to access pull on small tab labeled "OPEN". Always remember to unplug your guitar cords from the pedal to conserve battery life. Some battery drain may take place when unit is plugged in (even if the unit is bypassed). 7 8 9 10 Specifications Maximum Input Input Impedance Current Consumption Power Requirements +10dBu 1M ohm 27ma 9VDC <=300ma * CE Approved * Hints and Tips: Digital Delay pedals usually sound better when placed after distortion. Thus, if you are using a distortion pedal, place the Short Timer after the distortion pedal in the signal chain. If you are using the amplifier's distortion try putting the Short Timer in the effects loop section of the amplifier if you have it (please note - follow all instructions in your amplifier manual when using the effects loop). [. . . ] Some battery drain may take place when unit is plugged in (even if the unit is bypassed). 7 8 9 10 Specifications Maximum Input Input Impedance Current Consumption Power Requirements +10dBu 1M ohm 27ma 9VDC <=300ma * CE Approved * Hints and Tips: Digital Delay pedals usually sound better when placed after distortion. Thus, if you are using a distortion pedal, place the Short Timer after the distortion pedal in the signal chain. If you are using the amplifier's distortion try putting the Short Timer in the effects loop section of the amplifier if you have it (please note - follow all instructions in your amplifier manual when using the effects loop). [. . . ]