User manual ROCKTRON VVALVE

[. . . ] To insure against this possibility, always use good shielded cables for all audio input connections. This will help insure compliance with the Directive(s). Specifications OUTPUT SPEAKER WEIGHT DIMENSIONS POWER CONSUMPTION INPUT IMPEDANCE HEADPHONE IMPEDANCE LINE OUTPUT JACK EQ EFFECTS LOOP Copyright © 2002 GHS Corporation All Rights Reserved. 30 Watts Custom 10" Speaker (8 Ohms) 27 lbs. , 30 lbs. [. . . ] This will help insure compliance with the Directive(s). Specifications OUTPUT SPEAKER WEIGHT DIMENSIONS POWER CONSUMPTION INPUT IMPEDANCE HEADPHONE IMPEDANCE LINE OUTPUT JACK EQ EFFECTS LOOP Copyright © 2002 GHS Corporation All Rights Reserved. 30 Watts Custom 10" Speaker (8 Ohms) 27 lbs. , 30 lbs. Shipping Weight 17" (H) x 15. 5" (W) x 9. 5" (D) 430mm (H) x 394mm (W) x 240mm (D) 70 Watts 1M 32 Ohms or greater (600 Ohms for best results) 1/4" 4-band Yes Precautions NOTE: IT IS VERY IMPORTANT THAT YOU READ THIS SECTION TO PROVIDE YEARS OF TROUBLE FREE USE. THIS UNIT REQUIRES CAREFUL HANDLING. · All warnings on this equipment and in the operating instructions should be adhered to and all operating instructions should be followed. Care should be taken so that objects do not fall and liquids are not spilled into the unit through any openings. · The power cord should be unplugged from the outlet when left unused for a long period of time. DO NOT ATTEMPT TO SERVICE THIS EQUIPMENT. DO NOT MAKE ANY INTERNAL ADJUSTMENTS OR ADDITIONS TO THIS EQUIPMENT AT ANY TIME. See"Fuse Replacement" section for details on how to replace the fuse. Effects Loop Jacks These 1/4" jacks allow you to plug into outboard effects units. 2 Return/CD Input Plug the output of the effects unit into this jack. This 1/4" jacks allows you to plug a CD player into the amplifier so that you can jam along with songs. Send Jack Using a standard instrument cable with 1/4" jacks - plug this into the input of the effects unit. 3 Fuse Replacement We recommend that you use an authorized repair person to change the fuse in this unit. To access the fuse, first power down the unit and unplug the cable from the wall outlet and the amplifier. Using a small screw driver, open the fuse tray by prying open the small tab as shown in the drawing above. [. . . ] Send Jack Using a standard instrument cable with 1/4" jacks - plug this into the input of the effects unit. 3 Fuse Replacement We recommend that you use an authorized repair person to change the fuse in this unit. To access the fuse, first power down the unit and unplug the cable from the wall outlet and the amplifier. [. . . ]