User manual SAMSUNG HD300LD

[. . . ] Damaged or detached labels or any other components may directly cause product malfunction and void warranty. Samsung does NOT guarantee any data on your drive, please always BACK - UP your precious data. [. . . ] Installing the hard disk NOTE : SATA 1. 5Gb/s Speed Limit Jumper setting Only for SATA 3. 0Gb/s products In some rare cases SATA 1. 5Gb/s hosts can not establish SATA interface connection with SATA 3. 0Gb/s devices due to interface protocol issues. In this case the jumper may be installed as shown on the figure below to force the device to negotiate for SATA 1. 5Gb/s speed. Run the CMOS(BIOS) set-up program to detect the new hard disk drive. into CMOS screen the booting of 1 Go For descriptive detailsduring program, refer tothe computer. user's manual of the the computer's computer detect the hard disk. 2 Make thecomputer supports IDE HDD Auto Detection, the hard disk drive will automatically be detected. If your 1 2 3 If your computer does not support auto detect, go into the User Define Mode and by referring written information on the product, set the correct settings for Cylinder, Head, and Sector and if some Bios must be, set the HDD Mode to LBA. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate this from other types of wastes and recycle it responsibly to promote the sustainable reuse of material resources. Household users should contact either the retailer where they purchased this product, or their local government office, for details of where and how they can take this item for environmentally safe recycling. Business users should contact their supplier and check the terms and conditions of the purchase contract. This product should not be mixed with other commercial wastes for disposal. C Serial ATA host adapter 1. Attach the SATA interface cable to the interface connector on the hard disk drive. [. . . ] This product should not be mixed with other commercial wastes for disposal. C Serial ATA host adapter 1. Attach the SATA interface cable to the interface connector on the hard disk drive. [. . . ]