User manual SAMSUNG SC-8345

[. . . ] x Please recycle or dispose of the packaging material for this product in an environmentally responsible manner. OTHERS x Never store or ship the air conditioner upside down or sideways to avoid damage to the compressor. x The appliance is not intended for use by young children or infirm persons without supervision: Young children should be supervised to ensure that they do not play with the appliance. x Max current is measured according to IEC standard for safety and current is measured according to ISO standard for energy efficiency. E-2 Contents x PREPARING YOUR AIR CONDITIONER s Safety Precautions . x OPERATING YOUR AIR CONDITIONER s Selecting the Automatic Operating Mode . [. . . ] Result: x Each time you press the button: - The temperature is adjusted by 1C - The indoor unit beeps E-9 Cooling Your Room You must select the Cool mode if you wish to adjust the: Cooling temperature Fan speed when cooling 1 If necessary, press the Result: button. The operation indicator on the indoor unit lights up. The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped lt will start up normally after three minutes. IMPORTANT 2 If the is not displayed at the top of the remote control, button on the remote control one or more times until it press the appears. Result: The indoor unit beeps each time you press the The air conditioner runs in the Cool mode. button. Note 3 To adjust the temperature, press the button one or more times until the required temperature is displayed. Result: Each time you press the button: - The temperature is adjusted by 1C - The indoor unit beeps The air conditioner starts cooling, provided that the room temperature is higher than the selected temperature. If the room temperature reaches the set temperature, the air conditioner stops cooling, but the fan is still operating. button one or more times ) 4 Select the fan speed by pressing the until the required setting is displayed: Automatic (rotated : Low Medium High Maximum Result: Each time you press the beeps. button, the indoor unit 5 To control the direction of the air flow, refer to page 15. E-10 Removing Excess Humidity ENGLISH If the atmosphere in your room is very humid or damp, you can remove excess humidity without lowering the room temperature too much. 1 If necessary, press the Result: button. x The operation indicator on the indoor unit lights up. x The air conditioner starts up in the mode selected when the unit was last used. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: x Plugged in x Stopped It will start up normally after three minutes. IMPORTANT 2 If the is not displayed at the top of the remote control, press the button on the remote control one or more times until it appears. Possible time is between 1 hour and 24 hours inclusive. 2 Press the Result: button to complete the setting. x The air conditioner will switch off automatically when the counter displayed on the remote control reaches the set time and disappears the Off Timer setting. Example If you would like to turn the air conditioner on after 2 hours and to operate it for 2 hours: 1. button. You can see or change the setting mode and/or the temperature by pressing the button or the button after setting the Off Timer. To Cancel the Off Timer If you no longer wish to use the Off Timer that you have set, you can cancel it at any time. If you want to turn off the air conditioner before the timer reaches the setting time, press the button. E-17 Setting the Sleep Timer The Sleep Timer can be used when you are cooling your room to switch the air conditioner off automatically after a period of six hours. Note If you wish to switch the unit off at a specific time, refer to page 17. 1 2 Make sure that you have selected the Cool mode. x The air conditioner will be controlled as indicated in the illustrations below. Cooling The desired temperature is increased by 1C every hour. When it has been increased by 2C (after two hours), the temperature is maintained for four hours. To Cancel the Sleep Timer If you no longer wish to use the Sleep Timer that you have set, you can cancel it at any time. The air conditioner operates normally. E-18 Setting the 1 Hour Timer ENGLISH The 1 Hour Timer enables each mode to operate only for an hour and stop automatically with just one touch of the 1 Hour Timer button. It is good for you when you feel setting the Off Timer by pressing the Off Timer button several times is unnecessary and inconvenient. x The air conditioner will stop operating after an hour automatically. 2 To select an operating mode under the set 1 Hour Timer, press the button until the desired mode is displayed at the remote control. Result: The air conditioner will run and stop operating in the selected mode with the 1 Hour Timer set. Note If you operate the 1 Hour Timer when the air conditioner is turned off, the air conditioner will start operating and be turned off after an hour. To cancel the 1 Hour Timer If you no longer wish to use the 1 Hour Timer that you have set, you can cancel it at any time. [. . . ] x Check that you are pointing the remote control at the remote control sensor in the right of the indoor unit. x Check that the correct operating mode has been selected (Auto, Cool). x Dust may be blocking the air filter guard; refer to page 23 for cleaning instructions. x Check that the operating mode is set to the Auto, Cool or Fan mode ; in the Dry mode, the fan speed changes automatically. [. . . ]