User manual SAUNIER DUVAL SDH 12-035NW

[. . . ] Do not insert fingers or other objects in the air inlets and outlets or in the slats whilst the air conditioner is in operation since the high speed of the fan could cause injury. Call the technical specialist in order to take the appropriate preventative measures in the event of a refrigerant gas leak. If the air conditioner is alled in a small room, ensure that the necessary measures are taken to prevent any symptoms of lack of oxygen in the event of a refrigerant leak. In the event that the air conditioner is removed and subsequently realled, its proper allation must be adequately verified. [. . . ] SLEEP: Press the button for more than 2 seconds to change to the energy-saving operation mode. To cancel the SLEEP mode press this button for more than 2 seconds again. The SLEEP mode can only be selected in COOL, HEAT, and AUTO mode and automatically adapts the most comfortable temperature for you. To switch the display back on, press the LED SENSOR button for less than 2 seconds once again. FOLLOW ME: Press the button for less than 2 seconds to activate the FOLLOW ME function. When activated, the remote control display shows the actual temperature at its location. The remote control will send this information to the indoor unit every 3 minutes, so the temperature at the location of the remote control can be held constant. To deactivate the FOLLOW ME function, press the FOLLOW ME/AUTOCLEAN button for less than 2 seconds again. AUTOCLEAN: Press the button for more than 2 seconds to activate the AUTOCLEAN mode. In the AUTOCLEAN mode, the unit will will clean and dry the evaporator automatically and keep it fresh for the next operation. If the operation mode is changed or the unit is switched off, the FOLLOW ME function is cancelled, too. When the unit is switched OFF the indicator is cleared from the display. The clock is only displayed if no timer AUTO-ON/OFF settings are selected. Fan speed indicator Displays the selected fan speed in the AUTO mode and in " (MED), and the three fan speed levels " " (LOW), " " " (HIGH). After LOCK function is cancelled by pressing LOCK button again, this indicator is cleared from the display. sLEEP indicator This indicator is displayed as long as the SLEEP function is selected. After SLEEP function is cancelled by pressing TURBO/SLEEP button for more than 2 seconds again, this indicator is cleared from the display. fOLLOW ME indicator This indicator is displayed as long as the FOLLOW ME function is activated. After the FOLLOW ME function is cancelled by pressing the FOLLOW ME/AUTO CLEAN button for less than 2 seconds, this indicator is cleared from the display. NOTE The above illustration which displays all indicators at the same time is shown for informational purposes only. Setting the clock Before starting the air conditioner operation, set the clock to the current time at the remote control according to the following instructions. Then, use the bottons TEMP/TIME Increase Decrease Each time one of these buttons is pressed and released again after a moment, the time indicator increases or decreases by one minute, depending which button is pressed. [. . . ] Before turning the unit back on, check the following: that the air filters are alled, that the air inlet and outlet are not blocked up, that the remote control is fitted with batteries and that the differential switch is connected. If the base is damaged or deteriorated, the unit could fall down and cause physical or material damage. we advise you to contact a reliable air conditioner specialist or the Saunier Duval Official Technical Services to contract a preventative maintenance service. This will help to prolong the life of your air conditioner and improve its performance. [. . . ]