User manual SAUTER SHD1212T

[. . . ] Do not use it for commercial or industrial purposes or for any other purpose than that for which it was designed. € Do not modify or attempt to modify any of the characteristics of this appliance. € Always unplug the hood before cleaning it or performing other maintenance acts. € Provide adequate ventilation for the room in the case of simultaneous use of the hood and other appliances powered by an energy source other than electricity. [. . . ] 1) Your hood can be connected to this outlet using a flue (minimum diameter Ø mm that is enamelled, in aluminium, flexible or made of inflammable material). If your flue is less than 125 mm in diameter, you must use the recycling mode. 1 • USING THE RECYCLING MODE If you do not possess an outlet to the exterior (pic. In this case, you should add an active carbon filter which will keep in odours. 2 24 EN 2 / INSTALLING YOUR APPLIANCE • ELECTRICAL CONNECTIONS During installation and maintenance operations, the appliance must be unplugged from the electrical grid; fuses must be cut off or removed. The electrical connections are made before the appliance is installed in its housing. Ensure that: — the electrical installation has sufficient voltage, — the electrical wires are in good condition, — the diameter of the wires complies with the installation requirements. Warning This appliance is delivered with a H 05 VVF power cord that has three- 0. It must be connected to the main power supply (which should be a 220-240 V single phase current) via a CEI 60083 standardised socket that should remain accessible after installation, in keeping with installation guidelines. We cannot be held responsible for any accident resulting from an inexistent, defective or incorrect ground lead. If the power cable is damaged, call the aftersales service department in order to avoid danger. Warning If the electrical installation at your residence requires any changes in order to hook up your appliance, call upon a professional electrician. Warning If the hood displays any malfunctions, unplug the appliance or remove the fuse corresponding to the electrical socket where your appliance is plugged in. 25 2 / INSTALLING YOUR APPLIANCE • ASSEMBLING THE HOOD Warning The hood must be installed in compliance with all applicable regulations concerning the ventilation of premises. In particular, the evacuated air should never be conveyed to a duct used to evacuate smoke from appliances that use gas or other combustible fuels. Unused ducts may only be used after approval from a competent specialist. The minimum distance between the cooking surface and the lowest part of the hood must be 70 cm at least. If the instructions for the hob installed under the hood specify a distance of more than 70 cm, this requirement must be respected. EN Pict 1 Fixing to the wall : — Mark a vertical line on the wall centred on the cooktop. € Mark on the wall the three holes that have to be drilled, using the supplied hood suspension hook and observing the recommended distance. € Drill the three 8 mm diameter holes in a suitable position and insert the plugs (part A Pic. € Before fixing the hood, mount the nonreturn valve on the motor outlet -Secure the hood’s fixing support, ensuring that it is perfectly level. [. . . ] Professional expertise serving individuals Clearit offers you professional products and solutions designed for the daily care of your household appliances and kitchens. They are on sale at your regular retailer, along with a complete line of accessories and consumable products. 32 EN 5 / TROUBLESHOOTING SYMPTOMS Ensure that: The hood is not working. Ensure that: • The selected motor speed is sufficient for the quantity of smoke and vapours to be cleared. [. . . ]