User manual SIMA DAKAR PLUS

[. . . ] 18220 Albolote, Granada (SPAIN) Company responsible for manufacturing and commercialising the below specified machine: DECLARES: That the above mentioned machine designed for masonry cutting of stone and other construction materials is in conformity with all applicable provisions of the Directive of Machines (2006/42/CE) and the national applicable regulations. The machine is also in conformity with EC applicable provisions: 2006/95/CE; 2004/108/CE; 2000/14/CE; 2002/44/CE; 2002/95/CE; 2002/96/CE The machine is also in conformity with the provisions of the following applicable norms UNE-EN 292-1; UNE-EN 292 -2; UNE-EN 294; UNE-EN 349; UNE-EN 60204-1; UNE-EN 12418; UNE-EN 1050 ; UNE-EN 953. WARNING: Pease read and understand perfectly the present instruction before using the machine. Thanks you for your trust in our products and for purchasing the TABLE SAW DAKAR PLUS model This manual provides you with the necessary instructions to start, use, maintain and in your case, repair of the present machine. [. . . ] Never use the machine for purposes other that those it has been designed for. Use normalised cables Make sure the feeding voltage is in accordance with the voltage indicated in the adhesive label on the machine. Make sure that the extension cords are not in contact with points of high temperature, oil, water, sharp edges. Also avoid trampling or crushing the cables by passing vehicles and do not put any objects on the machine. Do not use high pressure water to clean circuits or electrical elements. ATTENTION: You are to follow all safety recommendations mentioned in the present user manual and comply with all labour risks prevention norms in every location. The machine needs to be installed in well illuminated, stable and plane surface, free from any obstacles. Before starting-up the machine, we should have gone through all necessary safety measures (electrical connection, stability, protections, etc. When installing the machine, make sure the table on which it will be placed should be a horizontal, non bland surface. this machine IS NOT TO BE USED UNDER RAIN AND ALWAYSE WORK IN GOOD ILLUMINATION CONDITIONS. In this position, the operator can easily manage the cutting head and the piece to be cut. Once the power supply cable is connected, the motor and the water puma start-up only by pressing the green switch button. If you wish to transform the machine from Ø300 to Ø350 or the opposite, you have to be careful with the height you want and change the position of the motor as you can cut the cart with the disk. You need to start cutting slowly and maintain a constant progress in function of the material to be cut. DAKAR PLUS models have been design to performance either 90º or 45º cuts very easily. Diagonal cutting is effectuated in the same way as a right cutting: For a diagonal cutting, you need to use the ruler with a graduated semicircle (A, Fig. This ruler must rotate to look for required degrees to make the cutting. Once the degrees have been selected in the semicircle, you place the piece to cut on the cutting table marking the face of the graduated ruler as well as the front ruler upper face(Fig. To complete the cutting, proceed as per the straight cut instructions. The design of the cutter DAKAR PLUS model allows cutting maintaining the sliding cart fixed and making progress with a downward motion of the cutting unit. 9 till the unit is freed and the internal spring tension will draw up its highest point Then we will move the sliding cart with the work piece on to a position below the disc and proceed to cut holding the handle and pushing to cut down against the resistance of the spring. The advance shall be adjusted depending on material hardness and depth of cut (Fig. [. . . ] Repairs under warranty made by SERVÍ-SIMA are subject to some strict condition to guaranty a high quality and service. Guarantees all its products against any manufacturing defect; to take into account the conditions stated in the attached document "WARRANTY CONDITIONS". The latter would cease in case of failure to comply with the established payment terms. Reserves its right to bring modifications and changes to its products without prior notice. [. . . ]