User manual SMEG FL 164 AP

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual SMEG FL 164 AP. We hope that this SMEG FL 164 AP user guide will be useful to you.


SMEG FL 164 AP : Download the complete user guide (349 Ko)

You may also download the following manuals related to this product:

   SMEG FL 164 AP (385 ko)
   SMEG FL 164 AP (352 ko)
   SMEG FL 164 AP (362 ko)
   SMEG FL 164 AP (353 ko)
   SMEG FL 164 AP (373 ko)

Manual abstract: user guide SMEG FL 164 AP

Detailed instructions for use are in the User's Guide.

[. . . ] • Replace the fastener and the washer in reverse order into the opening of the lower hinge on the opposite side of the appliance. • Take off all door corners and interchange them (instead of the corner with a hole insert the one without the hole and vice versa). • Check the gasket, it shouldn't be creased and it should seal well. In case it does not fit perfectly, pull it out and rotate for 180°. [. . . ] • Disconnect the appliance from the power supply before repairing it (only a qualified technician should repair it), before cleaning and before replacing the light bulb. • Do not defrost the appliance with other electric devices (hair dryer etc. ) and never scrape the frost layer with sharp objects. • For the sake of environment protection - be careful not to damage the rear wall of the appliance (the condenser unit or the tubes for example when moving the appliance) or any part of the refrigerating system inside the appliance. • The refrigerating system of the appliance is filled with refrigerant and oil, so when the appliance is damaged, handle it with care and dispose it of in compliance with environmental protecting precautions. • The rating plate is inside the appliance or outside on the rear wall. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Disposing of the Worn Out Appliance • When your appliance finally wears out, dispose it of. If the appliance has a lock, break it, in order to prevent eventual accidents (danger of children get locked inside the appliance). • The refrigerating system of the appliance is filled with refrigerant and insulating substances which should be separately treated and processed. Call your nearest authorised service agent or specialised servicing centre. If you don't find one, contact your local authorities or your distributor. Be careful not to damage the tubes on the rear wall of the appliance (danger of pollution). Instructions for Use 27 Placing and Installation Choosing the Right Place Place the appliance in a dry and regularly ventilated room. Allowed ambient temperature depends on the model (class) of the appliance and is stated on the rating plate of the appliance. cooker, radiator, water heater or similar devices) and do not expose it to direct sunlight. The appliance should be positioned at least 3 cm away from the electric or gas cooker and at least 30 cm away from the oil or coal stove. Behind the appliance there should be free space at least 200 cm² wide and above the appliance the high kitchen units should be at least 5 cm away from the appliance in order to assure adequate ventilation of the condenser unit. Class SN (sub-normal) N (normal) ST (sub-tropical) T (tropical) Ambient temparature from + 10°C to + 32°C from + 16°C to + 32°C from + 16°C to + 38°C from + 16°C to + 43°C Connection to Power Supply Connect the appliance with the cable and plug to the power supply socket outlet with a ground terminal (safety socket). Required nominal voltage and frequency are indicated on the rating plate. The connection to the mains supply and earthing have to be made according to current standards and regulations. The operation of the light does not depend on the position of the thermostat knob. NOTE: • The appliance can be equipped with various accesories, depending on the model of the appliance. • Various accesories (spice container, tube holder or additional shelves) can be bought in authorised centres. Defrost Water Outlet (2) The interior of the refrigerator is cooled with cooling plate incorporated in the rear wall. Operation Control The appliance is controlled with thermostat knob, situated in the right upper part inside the appliance. [. . . ] • Sometimes unusual and stronger noise is heard, which is rather unusual for the appliance. − The appliance shall be placed and levelled firmly on solid base. − It should not touch the wall or kitchen units standing next to it. − Check the accesories in the interior of the appliance, they should be placed correctly in their positions; also check the bottles, tins and other vessels that might touch each other and rattle. Bulb Replacement Water is Leaking From the Refrigerator In case the discharge water outlet is clogged, or the defrost water drips over the channel, water leaks from the refrigerator. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE SMEG FL 164 AP




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual SMEG FL 164 AP will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.