User manual SMEG FQ75XPED

[. . . ] Remember that this user manual is also applicable for several other models. Explanation of symbols Throughout this user manual the following symbols are used: C A B Important information or useful hints about usage. Packaging materials of the product are manufactured from recyclable materials in accordance with our National Environment Regulations. Content 1 Important instructions for safety and environment 3 1. 1 General safety. 4 1. 4 Compliance with WEEE Directive and Disposing of the Waste Product: . [. . . ] Install the product at least 30 cm away from heat sources such as hobs, ovens, heater cores and stoves and at least 5 cm away from electrical ovens. Pay attention to store your food in refrigerator in closed containers. You can load maximum amount of food to the freezer compartment of the refrigerator by removing the freezer compartment shelf of drawer. Declared energy consumption value of the refrigerator was determined with the freezer compartment shelf or drawer removed and with maximum amount of food loaded. There is no risk in using a shelf or drawer suitable for the shapes and sizes of the foods to be frozen. Thawing frozen food in fridge compartment will both provide energy saving and preserve the food quality. Connecting the product to electric energy saving systems is risky as it may cause damage on the product. The ambient temperature of the room where you install the refrigerator should at least be 10°C. Operating your refrigerator under cooler conditions than this is not recommended. If two coolers are to be installed side by side, there should be at least 4 cm distance between them. 4. 2 Recommendations for the fresh food compartment 16 / 32 EN Refrigerator / User Manual Preparation 4. 3 Initial use Before starting to use the product, check that all preparations are made in accordance with the instructions in sections "Important instructions for safety and environment" and "Installation". • Clean the interior of the refrigerator as recommended in the “Maintenance and cleaning” section. • Run the refrigerator without putting any food for 6 hours and do not open its door unless certainly required. C C You will hear a noise when the compressor starts up. If you apply instructions in the Section 3. 12, your refrigerator calculates this time automatically and the Filter Change Waning indicator illuminates when the filter usage time has elapsed. Fridge Compartment Temperature Setting button Press this button to set the temperature of the fridge compartment to 8, 7, 6, 5, 4, 3, 2, 1 8. . . Press this button to set the fridge compartment temperature to the desired value. Quick Fridge button Press this button to enable the Quick Fridge function. Error Status indicator If the refrigerator does not cool adequately or if a sensor failure occurs, this indicator will be enabled. When this indicator is enabled, Freezer Compartment Temperature indicator will display "E" and Fridge Compartment Temperature Indicator will display numbers such as "1, 2, 3…". Numbers on the indicator provide information about the error for the service personnel. Quick Freeze button Press this button to enable the Quick Freeze function. Press the same button again to disable the function. Refrigerator / User Manual 19 / 32 EN Operating the product 16. Freezer compartment Temperature Setting button Press this button to set the temperature of the freezer compartment to -18, -19, -20, -21, -22, -23, 24, -18. . . Press this button to set the freezer compartment temperature to the desired value. [. . . ] Damaged/broken seal causes the refrigerator to run for a longer period of time in order to maintain the current temperature. 30 / 32 EN • Door seal of the fridge or freezer may be soiled, worn out, broken or not properly seated. >>> Refrigerator / User Manual Troubleshooting Freezer temperature is very low while the fridge temperature is sufficient. >>> Adjust the freezer temperature to a warmer degree and check. Fridge temperature is very low while the freezer temperature is sufficient. [. . . ]