User manual SMEG KFV92D

[. . . ] After unpacking, make sure that the appliance is undamaged and that the door closes properly. Any damage must be reported to your dealer within 24 hours after delivery of the appliance. Wait at least two hours before switching the appliance on in order to ensure the refrigerant circuit is fully efficient. Installation of the appliance and electrical connections must be carried out by a qualified electrician, in accordance with the manufacturer's instructions and local safety regulations 4. [. . . ] Do not use a fine, fragile glass to collect ice. NOTE: The first few batches of ice cubes may have an off-taste; Throw this ice away. Ice is dispensed from the automatic ice maker bucket in the freezer compartment. When the outside dispenser bar is pressed, a trapdoor opens between the ice bucket and the dispenser. When the glass is taken away from the dispenser bar, the trapdoor closes. The dispenser will not operate when the freezer compartment door is open. Large amounts of ice cubes should be taken directly from the bucket, not through the dispenser. Noise from the ice crusher is normal, and pieces of ice may vary in size. When changing from crushed ice to ice cubes, a small quantity of crushed ice will be dispensed along with the first cubes. After starting the appliance, it generally takes overnight before the first ice cubes are ready. · If the dispenser does not dispense ice when you press the bar, change the ice selection from ice cubes to crushed ice or vice versa, (see figure) so as to remove any ice blocks. · If the dispenser still does not dispense ice, wait two minutes and repeat this operation. The dispenser has not been used for extended periods, causing the ice cubes to melt together. Shake the bucket occasionally to keep cubes separate and to increase storage capacity. Large amounts of ice should be taken from the bucket, not through the dispenser. The first few batches of ice from a new ice maker may have an off-taste. Throw the first few batches away and make a new supply. The ice dispenser lever has been held in for too long. Off-taste or odour to ice. Ice absorbs airborne odours. Water quality. Food not properly wrapped. The ice bucket and the freezer compartment may need cleaning. Plumbing connections to ice maker. NOTE: Only use cubes from the ice maker. 45 MAINTENANCE AND CLEANING Before any cleaning or maintenance operation, unplug the appliance from the mains or disconnect the electrical power supply. Periodically clean the refrigerator and freezer compartments with a sponge dampened in a solution of lukewarm water and vinegar. · Do not use steam cleaners · Clean the condenser and seal. NOTE: The refrigeration system pipes are located near the defrost pan and can become hot. Always disconnect the refrigerator from the power supply before replacing any light bulbs. Removal of the refrigerator light cover: · Loosen the screw that secures the light cover · Pull downwards and slide the cover towards the rear of the refrigerator. [. . . ] Temperature inside the compartments may be influenced by various factors such as: position of the appliance, ambient air temperature, frequency of door opening. Avoid locations in direct sunlight or near a source of heat (oven, heating, etc. ). If this cannot be avoided, install the appliance respecting the following minimum distances: Coal or paraffin stoves: 30 cm Electric and/or gas stoves: 3 cm Install and level the appliance on a floor strong enough to take its weight and in an area suitable for its size and use. To allow product handling and sufficient air circulation, leave at least 1 cm clearance at the sides, above the appliance, and between the rear panel and the wall. 18 Removing the freezer door 19 Removing the refrigerator door 20 Mounting the freezer door 21 Mounting the refrigerator door 22 WATER CONNECTION Disconnect the appliance from the mains power supply before starting operations. · The ice maker and water circuit must be connected to a water supply of potable and/or chemically purified water. [. . . ]