User manual SMEG KSET900X

[. . . ] Children should not be allowed to tamper with the controls or play with the appliance. The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. [. . . ] If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area, after Electrical connection 7 installation. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area, after installation, apply a double pole switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions. Before re-connecting the hood circuit to the mains supply and checking the efficient function, always check that the mains cable is correctly assembled. Mounting Expansion wall plugs are provided to secure the hood to most types of walls/ceilings. However, a qualified technician must verify suitability of the materials in accordance with the type of wall/ceiling. The wall/ceiling must be strong enough to take the weight of the hood. This hood is designed for fitting in a cabinet or on some other support. The diameter of the ventilation duct must be the same as the that of the flange mounted on the ventilation hole on the hood. To mount the hood proceed as follows: Position the drilling template inside the left cupboard on the right hand side with the arrow point towards the back on the cupboard. Repeat the procedure for the right hand cupboard If the sides of the cupboards are 18 mm thick, insert 4 spacers Z on the sides of the hood. 8 Model with Self-supporting Metal Filters Removing the Grease Filters - Fig. Press the side handles C (some models are supplied with handles Z - Fig. Remove the pull-out drawer completely and mount the grease filter so that it covers the drawer. According to model in possession: Lamp D with hook locks type A - Fig. 2. 2 Move the bracket hook locks towards each other (in direction “Open” as printed on the plastic part of the lock). 1. 2 Move the hook locks as indicated by the arrows and completely remove the lamp from the housing (Fig. 1. 3). Operation The hood is fitted with a control panel with aspiration speed selection control and a light switch to control cooking area lights. It is recommended that the cooker hood suction is switched on for 5 minutes prior to cooking and to leave in operation during cooking and for another 15 minutes approximately after terminating cooking. Maintenance Additional instructions for the montage Box adjustement The hood can be installed in cabinets with different depths, the front of the box must always be in line with the cabinet. [. . . ] Always replace burnt-out lamps, according to what is provided for your appliance, with olive-shaped max. 40 Watt (E 14) bulbs, or neon-lamp 14 Watt max. , or PL lamp 11 Watt (one PL lamp appliance) or PL 9 Watt (two PL lamp appliance). Close the light cover support or the back grease filter support grate. [. . . ]