User manual SMEG KT90XU

[. . . ] Do Not Use For To Exhaust Hazardous Or Explosive Materials And Vapors. Do not cook or fry in a way that could result in flames being sucked into the hood and causing a fire. The hood surface can be cleaned with a damp cloth and a non-bleach liquid detergent. [. . . ] The minimum distance between the cooker and the lower part of the hood must be 750 mm for gas cookers and 650 mm for electric cookers (Fig. 1). If it has not been assembled by the manufacturer, you can assemble it using the supplied screws (for type 1) or pushing (for type 2) If the motor intake is equipped with a non-return valve, make sure it opens and closes perfectly. The following instructions will assist installation: a) The hood should be centred with respect to the cooker. b) The hood is supplied with two supports/hooks (a) (Fig 3) or bracket (b) that need to be fixed to the wall by means of wall anchors . The L1 holes for these supports are on the back of the hood (fig. 4) c) Remove the anti-grease filters, put the hood on the wall and mark the position of the holes for the supports/hooks. d) Drill the two previously marked holes after removing the hood from the wall. Ducted mode or Recirculation mode installation: Ducted mode: In the ducted mode, connect the motor outlet to the fumes outlet duct not less than 120mm diameter. Warning: if the hood is equipped with an active carbon filter, it must be removed (see page7) EN 4 Recirculation mode: Leave the motor intake free. Warning: if the hood is not supplied with an active carbon filter, it is necessary to buy it separately and assemble it before using the hood. m) Chimney assembly: Adjust the two telescopic chimneys to the required length (fig. Mark the holes on the wall for fixing the chimney bracket to the wall. Remove the chimney set, drill and fix the support racket to the wall by means of wall anchors. Put the chimney group back in place and fix it to the hood with the Z screws and to the chimney bracket with the L screws as shown in figure 6. ELECTRICAL CONNECTION It is recommended that all electrical connection operations are performed by a qualified technician. The plug and fuse must be in accordance with the rating plate inside the hood. Then connect it to a nearby, easily reachable socket in accordance with the rules in force. [. . . ] To reach the active carbon filters, it is necessary to remove the metal filters as shown above. B): press enough to overcome the spring’s resistance and remove the filter. C): unscrew the knob, remove the blocking racket and then remove the active carbon filter. [. . . ]