User manual SMEG SD7323LFLD2P

[. . . ] • Make sure that the electrical information on the rating plate agrees with the power supply. • Make sure not to cause damage to the electrical components (e. g. Contact the Authorised Service Centre or an 18 electrician to change the electrical components. • Connect the mains plug to the mains socket only at the end of the installation. [. . . ] To select a different set temperature refer to "Temperature regulation". If "dEMo" appears on the display, refer to "Troubleshooting" . Switching off 1. Disconnect the mains plug from the power socket. Temperature regulation Set the temperature of the appliance by pressing the temperature regulators. Default set temperature: • +5°C for the fridge 20 The temperature indicators show the set temperature. After a power failure the set temperature remains stored. Door open alarm An acoustic alarm will sound if the door is left open for a few minutes. The door open alarm conditions are indicated by: • a flashing Alarm indicator; • an acoustic buzzer. When normal conditions are restored (door closed), the alarm will stop. The buzzer can also be switched off by pressing any button. Shopping function If you need to insert a large amount of warm food, for example after doing the grocery shopping, we suggest activating the Shopping function to chill the products more rapidly and to avoid warming the other food which is already in the refrigerator. The Shopping function shuts off automatically after approximately 6 hours. To switch off the function before its automatic end, repeat the procedure. The function switches off by selecting a different fridge set temperature. ChildLock function Activate the ChildLock function to lock the buttons from unintentional operation. • A sudden cracking noise from inside appliance caused by thermic dilatation (a natural and not dangerous physical phenomenon). • A faint click noise from the temperature regulator when the compressor switches on or off. Hints for energy saving • Do not open the door frequently or leave it open longer than absolutely necessary. 23 • If the ambient temperature is high and the Temperature Regulator is set to low temperature and the appliance is fully loaded, the compressor may run continuously, causing frost or ice on the evaporator. If this happens, set the Temperature Regulator toward warmer settings to allow automatic defrosting and so a saving in electricity consumption. Hints for refrigeration Useful hints: • Meat (all types): wrap in a suitable packaging and place it on the glass shelf above the vegetable drawer. • Fruit and vegetables: clean thoroughly and place in a special drawer. Bananas, potatoes, onions and garlic must not be kept in the refrigerator if not packed. • Butter and cheese: place in a special airtight container or wrap in an aluminium foil or a polythene bag to exclude as much air as possible. • Bottles: close with a cap and place on the door bottle shelf, or (if available) on the bottle rack. Hints for fresh food refrigeration To obtain the best performance: • do not store warm food or evaporating liquids in the refrigerator • do cover or wrap the food, particularly if it has a strong flavour • position food so that air can circulate freely around it CARE AND CLEANING WARNING!The cabinet has been recently switched on or the temperature is still too high. Refer to "Door open alarm"or "High temperature alarm". Refer to "Door open alarm"or "High temperature alarm". Close the door. 25 Problem Possible cause The temperature in the appliance is too high. Solution Contact a qualified electrician or contact the nearest Authorised Service Centre. [. . . ] Contact the Authorised Service Centre. INSTALLATION Positioning Install the appliance in a dry, well ventilated indoors where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance. Climate class SN N ST T Ambient temperature +10°C to + 32°C +16°C to + 32°C +16°C to + 38°C +16°C to + 43°C • The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a qualified electrician. • The manufacturer declines all responsibility if the above safety precautions are not observed. [. . . ]