User manual SMEG SLV107E

[. . . ] Children should be supervised to ensure that they do not play with the appliance. CHAPTER -1: BEFORE USING THE APPLIANCE (CORRECT USAGE) 7 • Use your machine only for laundries that have been specified as suitable for washing by the manufacturer. • Before operating the washing machine, remove the 4 transportation screws and rubber spacers from the back of the machine. If the screws are not removed, it may cause heavy vibration, noise and product malfunction, (voiding the guarantee). • Your machine is not covered under warranty for faults caused by any kind of external factors (pesticides, fire, etc. ). [. . . ] • For your much stained laundries, select a programme including prewashing, and put ¼ of the detergent you will put in the detergent drawer in the 1st compartment of the detergent drawer while putting the remaining ¾ of it into 2nd compartment. • Use detergents produced for automatic washing machine in your machine. The amount of detergent you will use for your laundries is printed on the detergent package. • The higher the degree of hardness of the water the more detergent you will use. • The amount of the detergent you will use will increase as the amount of your laundries increase. • Put the softener in the softener compartment in the detergent drawer. • Softeners with high density are required to be thinned to a degree before being put in the drawer. Because high-density softener will clog the flush and avoid the flow of the softener. • You can use your liquid detergents in all programs without prewashing. For this, fit liquid detergent level plate in the accessories bag or the liquid detergent apparatus (*) into 2nd compartment of the detergent drawer and set the amount of liquid detergent according to the levels on this plate. (*)Machinery specifications may vary depending on the product purchased. CHAPTER -5: PRELIMINARY PREPARATION FOR LAUNDERING (OPERATING YOUR MACHINE) 42 • Plug your machine in. If you switch your machine to the standby mode, the Start/Standby led on the electronic display will blink. 60° 40° 30° Lavar avar Aclar. Planchado Prelavado Inicio 1000 800 600 fácil Pausa Inicio Pausa CHAPTER-5: PRELIMINARY PREPARATION FOR LAUNDERING (CHILD LOCK) 49 To avoid programme flow from being affected if programme buttons are pressed or programme button is turned when performing washing operation in your machine, child lock is available. Child lock will be activated in case pressed on both auxiliary functions 3 and 4 at the same time for more than 3 seconds. You can see the auxiliary function leds on the display when activated. 1000 800 600 60° 40° 30° Lavar avar Aclar. Fin Temp. C ent. Planchado Prelavado Inicio fácil Pausa If pressed any button while child lock is active, the Additional Function Leds will blink on the display. If while the child lock is engaged and any programme is running, the programme knob is switched to the CANCEL position and another programme is selected, the programme previously selected continues from where it left. To deactivate it, it will be sufficient to press on the same buttons for more than 3 seconds. When the child lock is deactivated, the Additional Function Leds will blink on the display. CHAPTER -5: PRELIMINARY PREPARATION FOR LAUNDERING (CANCELLING PROGRAMME) 50 If you want to cancel any programme running: 1- Switch the programme knob to “CANCEL” position. 2- Your machine will stop the washing operation and the programme will be cancelled. 3- To get rid of the water accumulated in the machine switch the programme knob to any programme. 4- Your machine will perform the necessary discharge operation and cancel the programme. [. . . ] Unplug the machine, turn off your faucet and contact the nearest authorised service. (*) E02 Wash Rinse The water pressure or the water level inside the machine is low. End E03 Wash Rinse End The pump is faulty or pump filter is clogged or electrical connection of the pump is faulty. Your machine has excessive amount of water. E04 Wash Rinse Your machine will discharge water by itself. Pursuant to discharging operation, turn off your machine and unplug it. [. . . ]