User manual SMEG TLS86-1

[. . . ] GB A. Programme selector B. “Start delay” button C. Programme sequence indicator Start delay indicator D. “Spin” button E. “Start(Pause)” button F. “Reset” button G. “Door open” indication PROGRAMME CHART I C Prelavaggio 1h. Centrifuga / Scarico 12h. 800 700 600 400 0 Avvio ritardato Prelavaggio Quick time Centrifuga Ingresso acqua Pulizia filtro Apertura porta Service G J Risciacquo intensivo Scarico Centrifuga Risciacquo & Centrifuga 95° Cotone 60° 40° 60° SuperEco 60° Sintetici 40° 30° 40° Delicati Annulla H F Anti piega Eco Cotone 40° 60° Avvio (pausa) This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately: H. “Service” indication I. “Water tap closed” indication J. “Clean pump” indication 1) Do not use liquid detergent for main wash if you Lana/ 20° A mano 40° B Max. Load kg Cotton 40 - 60 - 95 °C Cotone 40 - 60 - 95°C 6. 0 D Rapido 15’ Misti 40° 2) Do not use liquid detergent. have activated prewash option. A 30° E Detergents and Additives Prewash Main wash Softener Start Predelay wash Avvio Preritardato lavaggio Type of wash / Notes - for temperature selection, respect the manufacturer's recommendations on the care label Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. For washing heavily soiled laundry, the “Prewash” option can be selected. [. . . ] Important: Do NOT loosen the drain hose from the right connection, see arrow “B” on picture. Otherwise, there is the risk of leakage and of scalding with hot water. Firmly connect the drain hose tothe siphon or another outlet for drain water. If you need to add an extension, use a flexible hose of the same size and secure the unions with screw-on hose clips. Important: Make sure there are no kinks in the drain hose and take precautions against it falling while the washing machine is running. A B GB 4 ELECTRICAL CONNECTION Do not use extension leads or multi sockets. Electrical connections must be made in accordance with local regulations. 1) arning - this washing machine must be earthed W This washing machine is normally supplied with a mains lead having a plug fitted in the factory which has been checked for correct earth continuity. If the fitted plug is not suitable for your socket outlet, or if the machine’s mains lead is not fitted with a plug, you should fit a suitable new, good quality plug by following the instructions in (2) below. Any unsuitable plug should be cut off and disposed of in order to avoid a possible shock hazard should it be inserted into a socket. 2) ONNECTION TO A REWIRABLE PLUG - to be carried out only by a qualified electrician C The wires in the mains lead are coloured in accordance with the following code: BLUE - “NEUTRAL” (“N”) BROWN - “LIVE” (“L”) GREEN AND YELLOW - “EARTH” (“E”) To fit a new plug, proceed as follows: 2. 1) Polarized Plugs (e. g. The GREEN AND YELLOW wire must be connected to the terminal in the plug which is marked with the letter “E” or by the Earth symbol or coloured green and yellow. The BLUE wire must be connected to the terminal which is marked with the letter “N” or coloured blue. The BROWN wire must be connected to the terminal which is marked with the letter “L” or coloured brown. 2. 2) Non-polarized plugs (e. g. 2 pin with side earth contact) The wire which is coloured GREEN AND YELLOW must be connected to the earth contact. The other two wires should be connected to the two pins, irrespective of colour. FUSE REPLACEMENT If the mains lead of this washing machine is fitted with a BS 1363A 13 amp fused plug, replace the fuse only with an A. S. T. A. approved type conforming to BS 1362 and proceed as follows: Remove the fuse cover (A) and the fuse (B). For all other types of plug, the supply socket should be protected by a 16 A fuse or circuit breaker at the distribution board. GB 5 BEFORE THE FIRST WASH CYCLE To remove any residual water used in testing by the manufacturer, we recommend that you carry out a short wash cycle without laundry. Add a small amount of detergent (maximum 1/3 of the quantity the detergent manufacturer recommends for lightly soiled laundry) to the main wash chamber of the detergent dispenser. Select and start programme “Synthetics” at 60°C (see separate the programme chart). PREPARATION OF THE LAUNDRY Sort the laundry 1. Sort the laundry according to… • Type of fabric / care label symbol Cottons, mixed fibres, easy care/synthetics, wool, handwash items. • Size Wash items of different sizes in the same load to improve washing efficiency and distribution in the drum. • Fabric delicacy Wash delicate articles separately: use a special programme for Pure New Wool , curtains and other delicates. [. . . ] The appliance stops in the corresponding programme step; unplug it and check whether: • Kinks are present in the drain hose. • Filter or pump is blocked (see chapter “Cleaning the Filter/ Draining Residual Water”; make sure the water has cooled before draining the appliance). After problem has been removed, select and start “Drain” programme or push “Reset” button for at least 3 seconds; afterwards restart desired programme. If the fault occurs again, contact our After-Sales-Service (see next chapter). “Water tap closed” “Clean pump” GB 13 Failure indication lights up Indication on display (if available) “bdd” (in case your washing machine has no display: all lamps of the programme sequence indicator light up) Description - Causes - Solutions Appliance stops during the programme. [. . . ]