User manual SMEG WD5090-R

[. . . ] CAUTION indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. All safety messages will inform you of potential hazards, on how to reduce the risk of injury and what can occur if the instructions are not followed. IMPORTANT: Installation and grounding must comply with applicable codes. NOTE: This cooktop is NOT designed for installation in manufactured (mobile) homes or for installation in Recreational Park Trailers. [. . . ] DO NOT install this cooktop outdoors. 4 Important Safety Instruction WARNING - To reduce the risk of fire, electrical shock, injury to persons, or damage when installing the cooktop, some basic precautions must be followed, including: Read all instructions Proper installation is your responsibility. Have a qualified technician install and ground this appliance, in accordance with these installation instructions. It is the responsibility of the installer to comply with the installation clearances specified on the model/serial I. D. It is the customer's responsibility: 1 To contact a qualified electrician to install the appliance 2 To ensure that the electrical system is adequate and in conformance with the national ANSI/ NFPA 70 ELECTRICAL CODE ­ LATEST EDITION, or the CANADIAN ELECTRICAL CODE, C22. 11 ­ 1982 and CAN/CSA C22. 2 No. Before you plug in the electrical cord, make sure that all the controls are in the OFF position. Never modify or alter the construction of the appliance. - - - CAUTION: This unit is designed as a cooking appliance. Based on safety considerations, never use it for warming or heating a room. Immediately after installation inspect the appliance, following the instructions in this booklet. If the appliance doesn't work properly, disconnect it from the electrical power supply and call the technical assistance center. plate, when a four-wire or three-wire, single-phase 120/208-volt, 60 Hz, AC-only electrical supply is available, a 40ampere maximum circuit protection is required), fused on both sides of the line. Wire size and connections must conform to the requirements of the National Electrical Code, ANS/NFPA 70 ­ Latest edition (*) or CAN/CSA Standard C22. 1, Canadian Electrical code, Part 1 ­ Latest edition (**) and all local codes and ordinances for the kilowatt rating of the range. Copies of the standards listed may be obtained from: (*) National Fire Protection Association Batterymarch Park ­ Quincy, Massachusetts 02269; (**) CSA International 8501 East Pleasant Valley Road Cleveland, Ohio 44131-5575 . This appliance is manufactured with a yellow-green ground wire connected to the appliance frame. After making sure that the power has been turned off, connect the flexible conduit from the appliance to the junction box using a U. L. Picture 1 and Picture 2 and the instructions provided below are the most common way of connecting the appliance. Your local codes and ordinaces, of course, take precedence over these instructions. Complete electrical connections according to local codes and ordinances. This cooktop must be connected to a grounded, metallic, permanent wiring system, or a ground connector should be connected to the ground terminal or wire lead on the cooktop. [. . . ] Complete electrical connections according to local codes and ordinances. This cooktop must be connected to a grounded, metallic, permanent wiring system, or a ground connector should be connected to the ground terminal or wire lead on the cooktop. Connection at connection block must be copper wire only. 10 Instructions for the Installer NOTE: Use this method only if local codes allow connecting the cabinet ground conductor to the neutral wire of the power supply cord WARNING ELECTRIC SHOCK HAZARD Turn power supply off before connecting wires. Failure to follow these instructions can results in death, fire, or electrical shock. [. . . ]