User manual SMEG WI360LX

[. . . ] If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons in order to avoid a hazard. • Do not install this appliance in areas that are too humid or too colds, such as the construction appendices, garages or wine cellars. • When you move the appliance, lift it by the front edge to avoid scratching the floor. SAFETY INSTRUCTIONS Installation WARNING!• Follow the installation instruction supplied with the appliance. • Wait at least 4 hours before connecting the appliance to the power supply. [. . . ] However, it is also possible to turn off the light before the automatic turn off time. Open the door and press the light button. Door open alarm An acoustic alarm will sound if the door is left open for approximately 5 minutes. The door open alarm conditions are indicated by: • flashing alarm indicator; • acoustic buzzer. When normal conditions are restored (door closed), the alarm will stop. During the alarm, the buzzer can be switched off by pressing any button. Light button The light turns on automatically for 10 minutes, each time the door is opened and closed. The light has no negative effect on DAILY USE Cleaning the interior Before using the appliance for the first time, the interior and all internal accessories should be washed with lukewarm water and some neutral soap to remove the typical smell of a brand-new product, then dried thoroughly. Do not use detergents, abrasive powders, chlorine or oil-based cleaners as they will damage the finish. Top Compartment: The temperature can be adjusted between +6°C and +11°C. This compartment is ideal for wines, especially new reds and whites, to be consumed immediately. Bottom Compartment: The temperature can be adjusted between +11°C and +18°C. This compartment is ideal for storing and refining red or white wines for long periods. • The temperatures of this compartment are suitable for storing aged and fullbodied wines. • The bottles should be placed down in such a way that the corks do not dry. The door is in anti-UV darkened double glass to protect the wine from the light in case the refrigerator is located in a well-lit place. • The appliance light should not be switched on too often or for too long. • The bottles should be handled with care, to avoid agitating the wine. Wine arrangement 20 Follow the recommendations and advice received at the time of purchase or given in the technical documentation regarding the quality, duration and optimum storage temperature of the wine. Storage advice The storage time for wine depends on ageing, the type of grapes, alcoholic content and level of fructose and tannin contained in it. At the time of purchase, check if the wine is already aged or if it will improve over time. Recommended storage temperatures: • For champagne and sparkling wines, between +6°C and +8°C • For white wines, between +10°C and +12°C • For rose and light red wines, between +12°C and +16°C • Aged red wines, between +14°C and +16°C When placing various bottles on top of each other, make sure they do not touch the refrigerator cooling plate. Wine Cellar Bottle Holder The maximum possible weight on the bottle shelves is 30 kg. Remove the shelf and insert it between the two guides. Wine Cellar shelves Remove the shelves for cleaning. The bottom compartment is fitted with a basket useful for placing upright and sloping bottles. 21 activated in function of the appliance thermostat setting and ambient conditions. Air circulation The refrigerator compartment has a special AIRLIGHT fan which is automatically CARE AND CLEANING WARNING!Clean the inside and accessories with lukewarm water and some neutral soap. [. . . ] Position the steel compensator as indicated in the figure and insert the upper part under the head of the screws. Do a final check to make sure that: • All screws are tightened. Align the compensator with the steel door panel and tighten the screws. Assembly instructions for the compensator lower part of the door 1. With the door open, loosen the two screws situated in the lower part without unscrewing them completely. Insert the steel carter inside the compensator as indicated in the figure. TECHNICAL DATA Technical data Dimensions of the recess Height Width Depth mm mm mm 1780 560 550 27 Voltage Frequency Volts Hz 230-240 50 The technical information is situated in the rating plate, on the external or internal side of the appliance and in the energy label. ENVIRONMENT CONCERNS Please recycle all materials marked with the symbol . [. . . ]