User manual SOLAC CVG9700

[. . . ] Do not spray "vertical" steam on a garment hanging in the wardrobe or on a person. Vertical ironing must be done with the garment on a hanger and away from other garments, elements or persons. Keep the CVG in an upright position during storage, leaning on its heel part, set on a stable surface. [. . . ] To disconnect the CVG, never pull on the power cord, take out the plug. If the supply cord is damaged, it must be replaced by the manufacturer, one service agent authorized by SOLAC or a similarly qualified person in order to avoid a hazard. The CVG should not be used if it has been dropped or has a crack or leak in the water tank. If you observe any of these problems, take the CVG to a one service authorized by SOLAC. Please never leave the CVG unattended while it is connected to the supply. Children must be supervised to ensure they do not play with the appliance. This appliance is not for use by persons (including children) whose physical, sensorial or mental capacities are impaired, or who lack sufficient experience or knowledge, unless they have been supervised or instructed in the use of the appliance by a person responsible for their safety. IMPORTANT: When you want to dispose of the appliance, NEVER throw it in the rubbish. Instead, go to your closest CLEAN POINT or waste collection centre for subsequent treatment. , To iron without steam, simply do NOT press either of the steam buttons (4). It allows for wrinkles to be removed from delicate garments without any need to place them on the ironing board: jackets, coats, curtains, suede garments, etc. 2 Select the required ironing temperature with the temperature selector (3), place the CVG in an upright position and press one of the two steam buttons (4). ) Keep either of the two steam buttons (4) pressed to get steam during upright ironing. ) you will get damp, white steam that is easier to see, whereas at point (· If during ironing the tank runs dry, the operation/temperature LEDs (5) of all the levels will start to blink every second. 1 Disconnect the CVG, keep it in an upright position and refill the tank using the cup (6) that comes with it (fig. ) If it completely runs dry of water, a strange noise will be heard from the micro-pump. Do not press the steam buttons (4) if this noise is heard, as this may cause damage to the system. 1 To clean the outside of your CVG, use a cloth moistened in soapy water. [. . . ] , Do not clean with abrasive chemical products or solvents as it may attack certain plastic parts and / or remove some of the marks and / or indications. 2 Store your CVG in the vertical position, wind the cord round the heel and secure it with the clip. , Although the power cord is fitted with a 360º rotational elbow, NEVER FORCE this cord when winding it around the appliance on the first turn. [. . . ]