User manual SOLAC DEPIL CENTER DC7500

[. . . ] Do not use near bathtubs, sinks, showers or other recipients containing water. €¢ This appliance is exclusively for household use and not for industrial use. It is dangerous to use it for any purpose other than the one indicated. [. . . ] Never immerse the appliance in water or any other liquid, and do not put it in the dishwasher Do not touch the appliance with wet hands when in operation. The appliance must be connected to a power socket with a suitable ground connection. do not use on sensitive areas such as eyebrows , moles , warts , open wounds , cuts , burns , etc. IMPORTANT: When you want to dispose of the appliance, NEVER throw it in the rubbish bin. Take it to your nearest CLEAN POINT or the I waste collection centre closest to your home for processing. Lid Filter (removable) Tub 1 Tub 2 Light Temperature regulation controls i Hot wax hair removal has the advantage of reducing the rate of millimetres in length and skin should be clean without cream or talc. I After a few minutes the light will come on again and the wax should be at a suitable temperature for hair removal. 7 Using the spatula place a little wax on the back of your hand to test the temperature. I Thanks to the thermostat, the temperature of the wax will remain constant. 8 Run your hand along your legs using an upward motion to flatten out the hairs. 9 Using the large spatula, spread out the wax in strips of approximately 6 cm in length and 3 cm in width. Z Wax should always be applied in the opposite direction to the growth of the hair. As soon as it no longer sticks to the touch, press with the palm of the hand to make the skin stick, then raise the strip from the base and pull upwards with one swift movement. Z Do not wait for the wax to go cold, as it will become brittle and difficult to remove. I Remains of hair can be removed with a little alcohol or by pressing them with a ball of wax still soft. 11 Place the strips of used wax in the filter in tub 2 and set tub 2’s temperature regulator to wax melting mode (Fig. [. . . ] I For the removal of superfluous facial hair, use a very gentle 4 CLEANING AND MAINTENANCE ‹ Before cleaning, ensure that the depilator is unplugged. €¢ The appliance does not require any specific maintenance. €¢ If occasionally, a little wax has run onto the outer surface, you can easily remove it with your finger nail. [. . . ]