User manual SONY CCD-TR750

[. . . ] ⷠCompensation for the contents of recordings cannot be provided, even if recording or playback is not possible due to a malfunction of the camcorder, etc. ⷠTelevision programs, films, video tapes, and other materials may be copyrighted. A moulded plug complying with BS1363 is fitted to this equipment for your safety and convenience. Should the fuse in the plug supplied need to be replaced, a fuse of the same rating as the supplied one and approved by ASTA or BSI to BS1362 (i. [. . . ] When you connect your camcorder to outside power sources, [BRIGHT] is automatically selected for the setting. ⷠWhen you select [BRIGHT], battery life is reduced by about 10 percent during recording. Select to increase the recording time from that of the SP mode (2 times longer for TRV228E/428E, 1. The use of Sony cassettes is recommended to get the most out of your camcorder. If you record in the LP mode, a mosaic-like noise may appear or sound may be interrupted when you play back the tape on other camcorders or VCRs. ⷠFor TRV228E/428E: When you record a tape in the LP mode on your camcorder, recording is carried out in the standard 8 mm system. ⷠFor TRV255E/265E: When you mix recordings in the SP mode and in the LP mode on one tape, the playback picture may be distorted or the time code may not be written properly between the scenes. ) Select to record in the 16-bit mode (1 stereo sound with high quality). For TRV228E/428E: You can automatically adjust the recording condition to get the best possible recording. Your camcorder returns to the standby mode when adjustment is complete. b Notes · Each time you eject a cassette, this setting will be canceled. GON OFF Select to see an overview of the functions available such as when you are using this camcorder for the first time. You can view the demonstration only when the NIGHTSHOT PLUS switch is set to OFF. SHUT OFF] is set to [5 min] when the camcorder is used on the battery pack, the power will be turned off after approximately 5 minutes (p. Select not to display date, time and the camera settings data during playback. Set the time difference by turning the SEL/PUSH EXEC dial, the clock will be adjusted in accordance with the time difference. If you set the time difference to 0, the clock returns to the originally set time. GMELODY Select to play a melody when you start/stop recording, operate your camcorder with the SEL/PUSH EXEC dial, or when an unusual condition occurs on your camcorder. Select to cancel the melody, beep sound, shutter sound and operation confirmation beep. When approximately 5 minutes have elapsed while you do not operate your camcorder, the camcorder is automatically turned off to prevent the battery from becoming consumed. Select to deactivate the Remote Commander to prevent your camcorder from responding to a command sent by another VCR remote control unit. The setting returns to [ON] when you have the power source disconnected from your camcorder for more than 5 minutes. [. . . ] It is recommended you operate your camcorder about once a month to keep it in an optimum state for a long time. Do not add excessive pressure on the LCD screen, as it may cause damage. ⷠIf your camcorder is used in a cold place, a residual image may appear on the LCD screen. ⷠWhile using your camcorder, the back of the LCD screen may heat up. [. . . ]