User manual SONY CDX-GT29

[. . . ] Avoid installing the unit in areas subject to dust, dirt, excessive vibration, or high temperatures, such as in direct sunlight or near heater ducts. Use only the supplied mounting hardware for a safe and secure installation. How to detach and attach the front panel Before installing the unit, detach the front panel. [. . . ] Press (RELEASE), then slide the front panel a little to the left, and pull it off towards you. Attach part a of the front panel to part b of the unit as illustrated and push the left side into position until it clicks. When the installation and connections are complete, be sure to press the reset button with a ballpoint pen, etc. Be careful not to pinch any wires between a screw and the body of the car or this unit or between any moving parts such as the seat railing, etc. Connect the power connecting cord 6 to the unit and speakers before connecting it to the auxiliary power connector. Connect the yellow cord to a free car circuit rated higher than the unit's fuse rating. If you connect this unit in combination with other stereo components, the car circuit they are connected to must be rated higher than the sum of the individual components' fuse rating. notes on speaker connection · Before connecting the speakers, turn the unit off. Use speakers with an impedance of 4 to 8 ohms, and with adequate power handling capacities. Do not connect the terminals of the speaker system to the car chassis, and do not connect the terminals of the right speaker with those of the left speaker. Do not connect any active speakers (with built-in amplifiers) to the speaker terminals of the unit. Warning If you have a power aerial without a relay box, connecting this unit with the supplied power connecting cord 6 may damage the aerial. *1 Note for the aerial connecting If your car aerial is an ISO (International Organization for Standardization) type, use the supplied adapter 7 to connect it. First connect the car aerial to the supplied adapter, then connect it to the aerial jack of the master unit. [. . . ] *1 Note for the aerial connecting If your car aerial is an ISO (International Organization for Standardization) type, use the supplied adapter 7 to connect it. First connect the car aerial to the supplied adapter, then connect it to the aerial jack of the master unit. Anslut först antennen till medföljande adapter och därefter till antennuttaget på huvudenheten. [. . . ]