User manual SONY DSX-S300BTX

[. . . ] Disposal of waste batteries (applicable in the European Union and other European countries with separate collection systems) This symbol on the battery or on the packaging indicates that the battery provided with this product shall not be treated as household waste. On certain batteries this symbol might be used in combination with a chemical symbol. The chemical symbols for mercury (Hg) or lead (Pb) are added if the battery contains more than 0. By ensuring these batteries are disposed of correctly, you will help prevent potentially negative consequences for the environment and human health which could otherwise be caused by inappropriate waste handling of the battery. [. . . ] If you select the Bluetooth Phone source after the connection is made, the network name and the connected cellular phone name also appear in the display. 1 Be sure that both this unit and the audio device are switched to Bluetooth signal on. Connecting to the cellular phone last-connected from this unit 1 Be sure that both this unit and the cellular phone are switched to Bluetooth signal on. Some cellular phones require permission to access their phonebook data during handsfree connection to this unit. While streaming Bluetooth audio, you cannot connect from this unit to the cellular phone. tips · With Bluetooth signal on: when the ignition is switched to on, this unit reconnects automatically to the last-connected cellular phone. but automatic connection also depends on the cellular phone's specification. You can also select the Bluetooth Phone source by pressing and holding (BROWSE) on this unit for 2 or more seconds, or pressing (CALL) on the card remote commander. Once the unit is connected to the cellular phone, you can make/receive handsfree calls by operating this unit. 3 Rotate the multi way encoder to select an initial from the initial list, then press it. 4 Rotate the multi way encoder to select a name from the name list, then press it. 5 Rotate the multi way encoder to select a number from the number list, then press it. Calling from the call history 3 Rotate the multi way encoder to select a name and phone number from the call history, then press it. The built-in microphone of this unit is located on the rear of the front panel (page 15). Calling by direct phone number input You can call by direct phone number input using only the card remote commander. 1 Press (CALL) on the card remote commander to select the Bluetooth Phone source. 2 Press the number buttons (0-9, or ) on the card remote commander to enter the phone number. You can select an auto answer setting from "off, " "Short" or "Long" (page 42). You can switch the ringtone from "Default" or "Cellular" (page 42). * Depending on the cellular phone, this unit's ringtone may be output even if set to "Cellular. Calling by preset number 2 Push the multi way encoder up/down to select the contact you want to call, then press it. Operations during a call presetting the volume of the ringtone and talker's voice You can preset the volume level of the ring tone and talker's voice. [. . . ] The playback sound stops momentarily when the connection between this unit and the cellular phone is being made. Turn off the unit by pressing (SOURCE/OFF) for 2 seconds, then turn the unit on again. If the sound is output from the cellular phone, set the cellular phone to output the sound from the car speakers. Device Inside If you turn the ignition switch to the OFF position without removing the USB device or iPod, "Device Inside" will appear in the display. [. . . ]