User manual SONY HCD-H50 SERVICE MANUAL

[. . . ] * DOLBY noise reduction manufactured under license from DolbyLaboratories Licensing Corporation. The instructions in this manual are for the tuner CD player HCD-H50, the optional MiniDisc deck MDS-MX101 and the optional stereo cassette deck TC-TX101. The instructions of the MiniDisc deck and the stereo cassette deck are only for the customers who purchased MDS-MX101 and TC-TX101. This manual explains how to operate: ­ Tuner CD player: HCD-H50 ­ MiniDisc deck: MDS-MX101 (option) ­ Stereo cassette deck: TC-TX101 (option) 34 Starting recording with 6 seconds of prestored audio data . [. . . ] Note that the tracks before and after this three-second space may be recorded as a single track with a single track number. During recording pause, press EDIT/NO on the MD deck repeatedly until "S. The MD deck replaces the silence of 30 seconds with a blank of about 3 seconds and changes to recording pause. The Smart Space and Auto Cut functions are both turned on at the same time. When "Smart Space" appears during recording, the Smart Space function is activated. If you turn the power off or disconnect the mains lead, the MD deck will recall the last setting (on or off) of the Smart Space and Auto Cut functions the next time you turn the power on. When you record from a CD (digital recording), the track numbers are automatically marked. In addition, you can mark track numbers: · At any point while recording. Marking track numbers automatically while analog recording The MD deck adds track marks differently in the following cases: · When recording from CDs The MD deck marks track numbers automatically. ⷠWhen recording a radio programme or from a tape While "LEVEL-SYNC" lights up, the MD deck marks a new track number whenever the signal level drops and rises to a certain point. Marking track numbers at a specific point while recording ⭠Level Syncro recording You can mark track numbers at any time while recording, regardless of the type of sound source. "Complete" appears for a few seconds and the newly created track begins playing. The new track will have no track title even if the original track was labelled. To combine the divided tracks again, use Combine Function on this page. This function lets you put several tracks or several independently recorded portions into a single track. The total number of tracks decrease by one and all the tracks following the combined ones are renumbered. Press =0 or )+ until the second track of the two to be combined appears. " appear alternately and the portion where the two tracks will join (i. , the end of the first track and the beginning of the second track) is played repeatedly. If you want to cancel the combine function at this time, press EDIT/NO or p. This function lets you cancel the last edit and restore the contents of the MD to the condition before the edit. Note, however, that you cannot undo an edit if you do any of the following after the edit: · Update the TOC by turning the power off or ejecting the MD. [. . . ] If you run into any problem using this stereo system, use the following check list. First, check that the mains lead is connected firmly and the speakers are connected correctly and firmly. "DAILY" or "REC" does not appear even if you press TIMER SELECT. Remove the CD and leave the system turned on for about an hour until the moisture evaporates. [. . . ]