User manual SONY HCD-H55 SERVICE MANUAL

[. . . ] INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. [. . . ] The sound of the rear channel is output from the front (L and R) speakers. The bass sound of the center channel is output from the front speakers, since a small speaker cannot produce enough bass. Even for video software which does not carry the qmark Some commercially available software may have Dolby surround processed sound tracks even though it is not indicated on the package. For maximum enjoyment of surround sound when playing any program source, adjust the front, rear, and center (if connected) speakers to the same volume level. The adjustment must be done with a test tone in the DOLBY SURROUND mode, but once the level is adjusted it can be used for all surround modes. You can adjust the volume level from your listening position by using the remote. "TEST TONE" appears on the display and the test tone will be heard from each speaker in the following order. Adjust the volume level so that the sound from each speaker is the same level at the listening position. To adjust the center level or rear level, TREBLE/CENTER ­/+ or BASS/REAR ­/+ on the main unit can also be used. Select the Dolby pro logic mode with the DOLBY PRO LOGIC MODE buttons on the main unit according to your speaker system. The delay time is the time between the surround sound from the front and rear speakers. To prevent accidental erasure To protect side A Break off the tab of side A. If the sound is affected by a television set during dubbing, turn off the set or move it away from the unit. Press § to open the cassette compartments, insert the tapes with the sides to be played or recorded facing you and close the cassette compartments. The unit enters recording pause mode for high speed dubbing, the P and r indicators light. (Dubbing can not be carried out by pressing the HIGH SPEED DUBBING button. Before playing a disc, turn on the SYSTEM POWER and set the function selector to the CD mode. Track number being played Caution on adjusting volume Do not turn up the volume while listening to a portion with a very low level or no audio signals. The OPEN/CLOSE and DISC SKIP buttons, however, can be operated in any mode (including TUNER). ⷠThe disc number of an empty tray will be displayed until the empty tray is set to play. To play an 8 cm (3-inch) CD If the disc is provided with an adaptor, first remove it, then place the disc on the inner circle of the tray. When there are no disc at all on the tray "no d1SC" appears on the display. [. . . ] To cancel time edit Press CONTINUE and return to the continuous playing mode. To erase the entire program Press p once during stop; twice during playback. The program is also erased when you turn off the unit or open the disc table. The unit will place your selections at the beginning of its program and add other tracks to fill in any remaining time. [. . . ]