User manual SONY ICF-C707

[. . . ] 4-180-721-11(1) FM/AM Clock Radio Operating Instructions For customers who purchased this product in the USA Please register this product on line at http://www. sony. com/productregistration. Proper registration will enable us to send you periodic mailings about new products, services, and other important announcements. Registering your product will also allow us to contact you in the unlikely event that the product needs adjustment or modification. Thank you. Important Safety Instructions 1) 2) 3) 4) 5) 6) 7) Read these instructions. [. . . ] 620 g (1 lb 5. 87 oz) including power supply unit and CR2032 battery Supplied accessories AM loop antenna (1) Design and specifications are subject to change without notice. This unit includes a preinstalled Sony Lithium battery (CR2032) as back-up power source for the clock, which is preset to EST (Eastern Standard Time) at the factory. And this battery is considered part of the product. Built-in audio cable Setting the clock for the first time This unit is preset to current EST (Eastern Standard Time) at the factory, and is powered by a backup battery. All you need to do the first time is just plug it in and select your time zone. Notes While setting the clock, you must perform each step within 65 seconds, or the clock setting mode will be cancelled. When pressing any of the rear buttons, hold the unit firmly to prevent slippage. Improving the reception FM: Extend the FM wire antenna fully to increase reception sensitivity. Rotate the antenna horizontally for optimum reception. 3 Press TIME SET + or ­ to select the 4 To display the year and date Press DATE/TIME ZONE once for the year, and press again for the date. After a while, the display will change back to the current time automatically. NATURE SOUND / PRESET 1 to 5, and press ALARM ON/OFF A or B. Improper use of the external temperature sensor may cause a malfunction. The display temperature and actual temperature may differ depending on the usage environment. Do not place the temperature sensor near the floor, a heat source such as a radiator or airduct, or in a place subject to direct sunlight. The temperature sensor reading may differ from actual surrounding temperature. The operating temperature range is 5 °F (­15 °C) to 122 °F (50 °C). In the case of lower than 5 °F (­15 °C) or higher than 122 °F (50 °C), the "Lo" or "Hi" indicator appears. When plugging in the unit or recovering from a power interruption, the temperature display of this unit will flash "--". The temperature will be displayed after 20 seconds. Selecting a Nature Sound This unit includes 5 types of Nature Sounds: (Sea Waves, Birds, Rain, Brook and Under the Sea. ) You can choose any one of these by pressing the corresponding button. Icons Sound type Sea Waves Birds Rain Brook Under the Sea Note When other functions are in use, Nature Sound is not available. Setting the radio alarm 1 Perform steps 1 to 5 in "To set the alarm. " 2 Press TIME SET + or ­ to select "RADIO" alarm mode, and press ALARM ON/OFF A or B. To doze for a few more minutes Note When the alarm is sounding, the brightness function cannot be used. 3 Press TIME SET + or ­ to select the "RADIO" appears in the display. Press SNOOZE / BRIGHTNESS. The sound turns off but will automatically come on again after about 10 minutes. You can change the snooze time by pressing SNOOZE / BRIGHTNESS repeatedly within 4 seconds. The maximum snooze time is 60 minutes. To stop the alarm AM band, FM band or the last station, and press ALARM ON/OFF A or B. Playing the radio Manual tuning 1 Press RADIO BAND to turn on the 2 3 radio and select the AM or FM band. Adjust the volume using VOL + or ­. 4 Press TIME SET + or ­ to select the 5 If you select the last station, jump to step 5. Press OFF ALARM RESET to turn off the alarm. The alarm will sound again at the same time depending on the next day setting. 4 Press DATE/TIME ZONE to set. Notes Though the clock is correctly set at the factory, discrepancies may arise during transport or storage. If necessary, set the clock to the correct time by referring to "Setting the clock. " While setting the time zone, you must perform each step within 65 seconds, or the time zone setting mode will be cancelled. station, and press ALARM ON/OFF A or B. Press TIME SET + or ­ to adjust the volume, and press ALARM ON/OFF A or B. The setting is entered. To deactivate the alarm Press ALARM ON/OFF A or B to turn off the ALARM "" or "" indicator in the display. [. . . ] Adjust the volume using VOL + or ­ and the connected component's volume. Preset tuning You can preset 5 stations for FM and 5 stations for AM. Built-in audio cable To cancel Automatic DST/Summer Time adjustment during the daylight saving time (summer time) period Setting the sleep timer You can fall asleep to the "NATURE SOUND, " "RADIO, " or "AUDIO IN" using the built-in sleep timer that turns off the "NATURE SOUND, " "RADIO, " or "AUDIO IN" automatically after a preset duration. 2 3 4 The VOL + button has a tactile dot. Automatic DST/Summer Time adjustment can be canceled. Press and hold DISPLAY/CLOCK and SNOOZE / BRIGHTNESS at the same time for at least 2 seconds while the clock is displayed. " " and "OFF" appear in the display to show that Automatic DST/Summer Time adjustment has been canceled. Notes Time change of Automatic DST/Summer Time adjustment (see above) is subject to variations in circumstances and laws of each country/region. [. . . ]