User manual SONY KLV-32BX300

[. . . ] If you damage the mains lead, it may result in fire or electric shock. The core conductors may be exposed or broken, causing a short-circuit, which may cause fire or electric shock. If the mains lead is damaged, stop using it and ask your dealer or Sony service centre to exchange it. Do not place this TV set in a place where medical equipment is in use. [. . . ] If the screen image becomes dark, flickers, or does not appear, the fluorescent lamp has worn out and should be replaced. Disposal of Old Electrical & Electronic Equipment (Applicable in the European Union and other European countries with separate collection systems) This symbol on the product or on its packaging indicates that this product shall not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Do not install the TV set in places subject to extreme temperature, for example in direct sunlight, or near a radiator, or heating vent. The TV set is not disconnected from the mains when the TV set is switched off. To obtain a clear picture, do not expose the screen to direct illumination or direct sunlight. If a VCR is installed in front of the TV set or beside the TV set, the picture may become distorted. For channel numbers 10 and above, enter the second digit within two seconds. In Text mode: Enters the three digit page number to select the page. This may take some time, please be patient and do not press any buttons on the TV or remote. Once all available channels have been stored, the TV returns to normal operation, displaying the channel stored on channel number 1. Turn off the TV temporarily (Standby mode) Turn off the TV completely Adjust the volume Mute the sound Return to the previous channel watched (for more than five seconds) Access the Programme index table Specified time period ­ Sleep Temporarily freeze and review the picture on the screen Press . When the TV is in standby mode (the 1/ (standby/sleep timer) indicator on the front of the TV flashes red), press TV "/1 on the remote to switch on the TV. To select channel numbers 10 and above using the number buttons, enter the second digit within 2. Each time you press /, the display changes cyclically as follows: Text mode t Text Superimpose mode t TV mode t Text mode t (repeat) To select a page, press the number buttons or PROG +/­. Adjusts higher-pitched sounds ("Treble"), adjusts lower-pitched sounds ("Bass"), and emphasizes left or right speaker balance ("Balance"). A/B/Mono: For a bilingual broadcast, select "A" for sound channel 1, "B" for sound channel 2, or "Mono" for a mono channel, if available. tip If you select other equipment connected to the TV, set "Dual Sound" to "Stereo", "A" or "B". You can select the options listed below on the "Features" menu. One Time Off: The TV speakers are temporarily turned off allowing you listen to the sound from external audio equipment. [. . . ] Fine-tunes the selected programme number manually if you feel that a slight tuning adjustment will improve the picture quality. Press M/m to adjust the fine tuning from ­15 to +15, then press OK twice. Sometimes a non-standard broadcast signal can cause sound distortion or intermittent sound muting when watching mono programmes. If you do not experience any sound distortion, we recommend that you leave this option set to the factory setting "Off". [. . . ]