User manual SONY RDP-XF100IP

[. . . ] · The unit requires at least 30 minutes to charge the battery if "LOW BATT" appears. · The battery indicator shows approximate remaining battery power. · Operating conditions will affect the rate of battery depletion. RECYCLING NICKEL METAL HYDRIDE BATTERIES Nickel Metal Hydride batteries are recyclable. You can help preserve our environment by returning your used rechargeable batteries to the collection and recycling location nearest you. [. . . ] · Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur. If you have any questions or problems concerning your unit, please consult your nearest Sony dealer. When charging completes, the full battery indicator appears. WARNING · Replace the battery for the remote commander with a Sony CR2025 lithium battery. 8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9) Do not defeat the safety purpose of the polarized or grounding-type plug. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. 10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the apparatus. 12) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. 2 Note · It will take approximately 7 hours to charge the battery. Important Safety Instructions 1) 2) 3) 4) 5) 6) 7) Using the rechargeable battery You can operate the unit with the rechargeable battery instead of the AC power adaptor. Note · The maximum output will be lower when the AC power adaptor is disconnected. 3 4 To check the remaining power of the battery The remaining power of the battery will be indicated when the unit is turned on. As the remaining battery power depletes, the battery indicator decreases. 5 Level 1 Level 2 Level 3 Level 4 Operations To set the iPod 1 Press PUSH OPEN on the Docking Tray at the front of this unit to open. · When placing or removing the iPod, hold the Docking Tray securely. · Before disconnecting the iPod, pause playback. The rechargeable battery is depleted. There is no audio. · Connect to the AC power adaptor to charge the battery. 4 Input AUDIO IN jack (ø 3. 5 mm stereo minijack) Power output 20 W + 20 W (at 1% harmonic distortion) (With the AC power adaptor) Power requirements Rechargeable battery pack: NH - 2000 RDP Battery life See "Battery life" of "Using the rechargeable battery" for details. 356. 0 mm × 162. 8 mm × 119. 7 mm (w/h/d) (14 1/16 inches × 6 7/16 inches × 4 3/4 inches) Mass Approx. 1. 9 kg (4 lb 3 oz) Supplied accessories Remote commander (1) AC power adaptor (1) AC power cord (1) Audio connecting cable (1) Universal Dock Adapter for iPhone (1) Universal Dock Adapter for iPhone 3G (1) Design and specifications are subject to change without notice. If a station cannot be preset automatically To external equipment Audio connecting cable (supplied) · Refer also to the connected equipment's manual. · The supplied audio connecting cable may not be usable with some external equipment. In this case, use a cord suitable for the external equipment you are using. · If you listen to the radio with external equipment connected, turn off the connected equipment to prevent noise. If noise occurs, even when the equipment is turned off, disconnect and place the external equipment away from the unit. Noise is heard. You may need to preset a station with a weak signal manually. · Ensure that the unit is not in the vicinity of in-use portable phones, etc. The display turns off. 1 Tune in the station you want. 3 Press / to select "PRESET, " and press ENTER. Notes · If no operation is performed for more than 30 seconds, the display turns off. Press DISPLAY to turn on the display again. "ERROR" appears in the display and the unit turns off automatically. · If this symptom occurs frequently, consult your nearest Sony dealer. Notes 4 Press / to select the desired preset number, and press ENTER. [. . . ] When an FM stereo broadcast is received, "STEREO" appears. iPod nano 2nd generation (aluminum) iPod 5th generation (video) iPod nano 1st generation To cancel the power off hold function Press and hold (power). "RELEASE" flashes 2 times and the power off hold function is canceled. The unit will turn on automatically. Tip · The power off hold function will be canceled if you connect the AC power adaptor to the unit. · If you touch or operate an iPod connected to this unit while listening to the radio, noise may occur. · If you are listening to the radio with an iPhone connected to the unit, interference with radio reception may occur. [. . . ]