User manual SONY VAIO VPC-CW15FX/P

[. . . ] AMD, AthlonTM, AthlonTM XP, ThoroughbredTM, and DuronTM are registered trademarks of AMD Corporation. Intel® and Pentium® are registered trademarks of Intel Corporation. PS/2 and OS ® /2 are registered trademarks of International Business Machines Corporation. W indows ® 95/98/2000/NT /XP/Vis ta are regis tered trademarks of Mic rosof t Corporation. [. . . ] This functionality allows the processor to classify areas in memory by where application code can execute and where it cannot. W hen a malicious worm attempts to insert code in the buffer, the processor disables code execution, preventing damage or worm propagation. Limit CPUID M aximum The Max CPUID Value Limit is designed to limit the listed speed of the processor to older operating systems. Intel Virtualization Technology This item is used to enable/disable the Intel Virtualization technology. For further information please refer to Intel's official website. Intel SpeedStep This item is used to enable/disable the Intel SpeedStep. For further information please refer to Intel's official website. North Bridge Press <Enter> to enter the sub-menu. 3-11 M S-7395 M ainboard M emory Information This screen displays the current system memory capacity. DRAM Remapping Above 4G Ensure your operating system is 64bit, when set to [Enabled], the feature allows your system identify more the 4GB memory. Flex M emory mode Flex memory mode provides the most flexible performance characteristics. The bottommost DRAM memory (the memory that is lowest within the system memory map) is mapped to dual channel operation; the topmost DRAM memory (the memory that is nearest to the 8 GB address space limit), if any, is mapped to single channel operation. [Enhanced] If Enhanced selected, "Configure SATA as" will be presented for setup. W hen it sets to [Disable], the system will disable the SATA port 3 and 4. Serial-ATA Port 1 / 2 / 3 / 4 This item is used to enable/disable specific Serial-ATA port. JMicron Controller Mode This item is used to simulate the IDE mode for JMicron ATA Controller. Then you do not need to install drivers when you are installing the operating system. USB Configuration Press <Enter> to enter the sub-menu. 3-13 M S-7395 M ainboard M odule Version This item shows the version of the current USB module. (read only) USB Devices This item shows the number of the USB device according type of device. Ex : show "2 Drives, 1 mouse" when you insert 2 USB flash disk and a mouse. Legacy USB Support Select [Enabled] if you need to use a USB-interfaced device in the operating system. Hotplug USB FDD Set to [Enabled] if your need to hotplug USB floppy disks. Device Reset timeout This item allows you set the reset timeout value. [. . . ] A status bar at the bottom of the screen shows the progress of the rebuilding. C-10 JMicron RAID Installing Driver Install Driver in Windows Vista / XP / 2000 New Windows Vista / XP / 2000 Installation The following details the installation of the drivers while installing W indows XP / 2000. W hen you start installing W indows XP and older operating systems, you may encounter a message stating, "Setup could not determine the type of one or more mass storage devices installed in your system". If this is the case, then you are already in the right place and are ready to supply the driver. If this is not the case, then press F6 when prompted at the beginning of W indows setup. [. . . ]