User manual SONY VPL-CS6

[. . . ] In this manual such names are not indicated by ® or TM symbols. This unit is equipped with the network presentation and control function. Any image of a computer, if it is connected to a LAN by wired or wireless connection, can be projected by connecting a network cable to the NETWORK connector (RJ45) of the projector. Operations such as power on/off or input selection of the projector or confirmation of the situation of the projector such as lamp used time is possible far from the projector. [. . . ] If you enter a different group name from that of the computer, the application software does not display the Projector button. ⷠIf you enter a different password from that of the When the projector and a computer that has a different network segment (subnet) are connected, set [PC Registration List] (page 10) on the projector and [Projector Setting] (page 17) on the computer. When the projector and a computer that has a different network segment (subnet) are connected, set [PC Registration List] (page 10) on the projector and [Projector Setting] (page 17) on the computer. Turn on the power of the projector and press the INPUT C or AIR SHOT key on the remote commander. 5 projectors may not be able to be connected at the same time due to the computer. ⷠWhen the projector and a computer that has a different network segment (subnet) are connected, set [PC Registration List] (page 10) on the projector and [Projector Setting] (page 17) on the computer. Press the M or m key on the remote commander to select the computer, and then press the ENTER key. Press the M or m key on the remote commander to select the computer to be connected from the list and then the ENTER key. When the projector and a computer that has a different network segment (subnet) are connected, set [PC Registration List] (page 10) on the projector and [Projector Setting] (page 17) on the computer. External monitor signal of notebook type computer may not be output when you use Projector Station for Air Shot Version 2. When [When a connection/Disconnection request is received] is set to [Always Yes] or [Always No] in the setting of the application software, the connection confirmation message does not appear and the application software always permits/ refuses connection/disconnection. To set each mode, select the desired mode button and then click [Setup] to display the Setup display of the mode. Click [Apply] in the lower part of each window to update the projector to the data input in each window. Time Server Enter the address of the time server when the time is set by a timer server. Immediately report if any error occurs with the projector (Error Report). ⷠSend warning e-mail messages when a preset time for use of the projector lamp has been reached (Lamp Reminder). ⷠSend warning e-mail messages when a preset time for maintenance of the projector has been reached (Maintenance Reminder). Error: Select this check box to arrange the sending of an error report if any problem occurs with the projector. Even if days are specified in the Report Timing field, you still must select the Regular check box to receive the Regular Report. If the day preset in "Every Month on Day" does not exist in the month, you will receive the e-mail message on the last day of the month. ⷠYou cannot specify the day of the week or day of the month if "Every Week on Days" or "Every Month on Day" is not selected. X Mail Form field Select the e-mail message type from "Standard" or "Simple. [. . . ] C Place the computer close to the access point, or remove the obstacles between the access point and computer. The password specified with the projector is not identical with those specified with the computer. The projector you are trying to communicate is performing turning on/off operations. C After the projector operations are complete, communicate it and turn it off again. [. . . ]