User manual STANDARD HORIZON CP300I

[. . . ] Color GPS Chart Plotters CP180/CP180i CP300/CP300i Owner's Manual CP180/180i CP300/300i WARNING!!!Electronic charts displayed by the GPS Chart Plotter are believed to be accurate and reliable, but are not intended to be a substitute for the official charts, which should remain your main reference for all matters related to the execution of safe navigation. For this reason we would like to remind you that you should carry on board and use the official published and approved nautical charts. FCC Compliance Statement This device complies with Part 15 of the FCC limits for Class A digital devices. This equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in accordance with the instructions may cause harmful interference with radio communications. [. . . ] As the upper side of the map is more compressed than the lower side, a wider map area is visible. The perspective view allows showing more chart information immediately ahead and around the cursor. Figure 6. 0. 2 - Perspective View To activate this function follow the procedure: 1. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move the ShuttlePoint knob to the right. Move the ShuttlePoint knob to highlight PERSPECTIVE VIEW and press [ENT] or move the ShuttlePoint knob to the right. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint knob to the left until the chart page is shown. 6. 0. 3 Dynamic Nav-Aids This function allows the Nav-Aids to be turned On or Off. The blink period and color of each Nav-aid is read from the Nav-Aid attributes available on the data cartridge. When the ship is inside the Nav-Aid nominal range, the light of the Nav-Aid will start blinking. Page 44 GPS Chart Plotters When Dynamic Nav-Aids option is set to On, when the flashing light is Off, or when fix position is out of the sector, the light color is displayed by using a faint light color. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move the ShuttlePoint knob to the right. Move the ShuttlePoint knob to highlight DYNAMIC NAV-AIDS and press [ENT] or move the ShuttlePoint knob to the right. Press [CLR] until the menu disappears or an easier method is to move the ShuttlePoint knob to the left until the chart page is shown. 6. 0. 4 Safety Status Bar (DSI - Data Safety Indicator) When Safety Status Bar is On, a status bar with six boxes showing the status of certain functions is displayed. Any warning or alarm condition is identified by the red color to indicate possible risk. Move the ShuttlePoint knob to highlight MAX FUNCTIONS and press [ENT] or move the ShuttlePoint knob to the right. Move the ShuttlePoint knob to highlight SAFETY STATUS BAR and press [ENT] or move the ShuttlePoint knob to the right. The menu now shows the following selections: ON (The Safety Status Bar is shown), OFF (The Safety Status Bar is not shown), ICON (The Safety Status Bar is not shown, but a Warning alarm Icon is shown on the corner of the map screen as soon as any item controlled by the DSI function returns an alarm condition. The Warning Icon remains displayed until the alarm condition persists. Placing the cursor over this Icon, a quick help message is shown next to the Icon, allowing the Safety Status Bar to be shown. In this case - when the Safety Status Bar is opened via Warning alarm Icon - it is allowed to obtain information about each "active" Safety Status box (the red ones): it is possible to select them by ShuttlePoint knob movement left/right, and a list of active alarms is shown underneath the selected box. Press [CLR] until the menu disappears or an easier method is to press the ShuttlePoint knob to the left a few times. Figure 6. 0. 4 - Safety Status Bar Boxes definition is as follows: Zoom Normal: when the chart is displayed at normal scale. Zoom: red when the chart is under-zoomed out more than twice normal scale, gray otherwise. GPS Chart Plotters Page 45 O. Zoom: red when the chart is over-zoomed in more than twice normal scale, gray otherwise. Chart Lock: red when the chart is zoomed in more than twice normal scale, gray otherwise. NOTE U. Zoom and chart lock are used with Flexi zoom selected. Best Map Red when a more detailed chart is available under the cursor position. Data Off Red when at least one of the following objects or layers is turned off (by the user): Depths/soundings; Wrecks/obstructions; Tracks/routes; Attention Areas; Nav-Aids. Declutter Displays red when clearing overlapping objects. Dangers Red when "Guardian Technology" detects one of the following objects: Land, Intertidal, Depth Area, Rocks, Obstructions, Shoreline Constructions, Fishing Facility, Wrecks, Dragged area, Diffusion area, Mooring facilities, Pingos and Production installations. Caution Red when "Guardian Technology" detects cautionary or restricted area. 6. 0. 5 Currents Prediction It is possible to see the variation of the Tidal arrows on the selected area at any given time. [. . . ] XTE (Cross Track Error) ­ The distance your vessel is off course (left or right) to a Destination point. Page 98 GPS Chart Plotters ANALITYCAL INDEX A Adjusting Time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12, 16, 18, 57, 93 GPS Chart Plotters CP300 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12, 17, 20, 34, 43, 57, 67, 94 Creating a Route . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 61 Page 100 GPS Chart Plotters Resolution . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]