User manual STANTON C.313

[. . . ] BROWSE ­ This encoder enables you to browse the tracks on your CD without actually selecting each one as you go down the list. LCD DISPLAY ­ Shows various information on the status, modes, and functions of the unit. FOLDERS ­ In the same fashion that you BROWSE (#2) tracks, you can use this encoder to browse a list of folders. Use it together with the BROWSE encoder to browse and select tracks. 5. [. . . ] · Be sure the player is in a well-ventilated area where it will not be exposed to direct sunlight, high temperatures, or high humidity. · Try to place the unit as far as possible from Tvs and tuners, as the unit may cause undesirable interference. · The player will work normally when the unit is within 15 degrees of the vertical plane. If the unit is tilted excessively, discs may not load or unload properly, or playback may be adversely affected. CAUTION CONNECTIONS · Make sure that the unit and any other equipment in the signal chain are · Be sure to use the supplied cables. · Connect the RCA cable to the rear of the unit and to the input on your · To avoid severe damage to the unit, be sure the power is OFF when making any connections. · Connect the power cable to the rear of the unit and to a proper AC outlet. 6 OPERATING INSTRUCTIONS UPDATING FIRMWARE Checking Firmware Version · Turn the unit off. Updating The Firmware Firmware updates may, as necessary, become available from Stanton's website (www. stantondj. com) as downloadable ISO files, which are needed to create a bootable CD. We recommend using Magic ISO Maker (www. magiciso. com) PC software to burn the disc. · Once you have burned a bootable disc from the ISO file, insert the CD into the C. 313. · The unit will automatically eject the CD once the update is complete. · Turn the unit off and back on to complete the update process. Browsing · Turn the BROWSE encoder to browse the list of tracks on the CD. · While the track number is flashing, push down on the encoder to select the track. · If it is an MP3 disc with folders, use the FOLDER encoder to browse folders as desired. · Pushing down on the encoder will enter or exit folders. STARTING PLAYBACK Press the PLAY/PAUSE button during the pause or cue mode to start playback. The PLAY/PAUSE button illuminates with a solid green light during playback. STOPPING PLAYBACK OPENING AND CLOSING There are two ways to stop playback. Press the PLAY/PAUSE button during playback to pause at that point, or press the CUE button during playback to return to the position at which playback started. Press the OPEN/CLOSE button to open or close the disc tray, or press the PLAY button and the disc tray will close automatically. If the tray is not closed after 60 seconds it will close automatically and enter pause mode. This prevents playback from being interrupted if the OPEN/CLOSE button is pressed accidentally. Stop playback by engaging cue or pause mode, and then press the OPEN/CLOSE button. CUEING LOADING DISCS Cueing is the action of preparing tracks for playback. When the CUE button is pressed, playback returns to the cue point and enters pause mode. [. . . ] Any returns to a non-authorized dealer or to an authorized Stanton dealer not in the same country as the merchandise was intended to be sold or as set forth above will void this warranty. To initiate a warranty repair, you must contact the authorized Stanton dealer from whom you purchased the merchandise, and follow such authorized Stanton dealer's return policy. Stanton assumes no risk and shall be subject to no liability for damages or loss resulting from the specific use or application made of the merchandise. Stanton's liability for any claim, whether based on breach of contract, negligence, infringement of any rights of any party, or product liability, and relating to the merchandise shall not exceed the price received by Stanton from your purchase of such merchandise. [. . . ]