User manual STANTON C.501

[. . . ] IMPORTANT TO SAFETY IMPORTANT TO SAFETY WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord. [. . . ] 3) Connect the control cords to the REMOTE connector on the main unit. Otherwise the units may not work properly. NAMES AND FUNCTIONS Main Unit Front Panel (1) POWER (Power ON/OFF Switch) When the POWER switch is pressed, the power turns on. The disc holder cannot be opened during playback, so stop playback before pressing the button. (4) REMOTE CONTROL CONNECTOR Connect this connector to the control unit using the included control cord. (5) AUDIO OUT The audio signals from each player are output from these jacks. Connect the output to the respective input of a digital amplifier for example. 5 NAMES AND FUNCTIONS Control Unit (1) OP/CL Press it to open and close the disc holder. The disc holder cannot be opened during playback, so stop playback before pressing the button. (2) TIME (Time Button) Press this button to switch the time display among the elapsed time and remaining time and total remaining time of the disc. When Disc 1 ends the CD player will automatically change to Disc 2 and when Disc 2 ends it will return to Disc 1, etc. (5) PITCH - BUTTON more to resume playback. (10)SGL/CTN (Single/Continuous Button) Press it to switch between the single and continuous play modes. The SINGLE mode is indicated by the SINGLE indicator on the LCD (11)CUE (Cue Button) Press the CUE button during playback to return to the position at which playback started. (12)+10/-10 Use the button to skip ahead 10 tracks. Release the button to return to the original BPM. (6) PITCH + BUTTON The CD speeds up while this button is pressed. Release the button to return to the original BPM. (7) PITCH LOCK Use these button to go back to the beginning of the current track or select a previous track for playing. Loading discs Hold the disc by the edges and place it in the disc holder, then press the OPEN/CLOSE button again to close the disc holder. The unit will show the total track number and the total playing time for about 2 seconds then enter the cue condition, the cue point will be set to the music starting point of the first track automatically. Figure 2-1 CAUTION: Do not place any foreign objects in the disc holder, and do not place more than one disc in the disc holder at a time. Do not push the disc holder in manually when the power is off, as this may result in malfunction and damages the player. 3. Selecting Tracks Press the SKIP button once to move to next higher or lower track. When a new track is selected during playback, playback begins as soon as the skip search operation is completed. If the skip button is pressed while at the last track, the first track is selected. In the same way, if the skip button is pressed while at the first track, the last track is selected. 4. Starting Playback Press the PLAY/PAUSE button during the pause or cue condition to start playback, the PLAY indicator lights. The point at which playback starts is automatically stored in the memory as the cue point. [. . . ] Do not use benzene, thinner, water, record spray, electrostatic-proof chemicals, or silicone-treated cloths to clean discs. Always handle discs carefully to prevent damaging the surface; in particular when removing a disc from its case or returning it. Do not write on the label (printed side) with a hard-tipped implement such as a pencil or ball point pen. Condensation will form if a disc is brought into a warm area from a colder one, such as outdoors in winter. [. . . ]