User manual STANTON C314

[. . . ] C. 314 PROFESSIONAL TABLETOP CD PLAYER USER MANUAL IMPORTANT SAFETY INSTRUCTIONS 1. Read Instructions ­ All the safety and operating instructions should be read before this product is operated. Retain Instructions ­ The safety and operating instructions should be retained for future reference. Heed Warnings ­ All warnings on the appliance and in the operating instructions should be adhered to. [. . . ] TEXT ­ The text portion of the display (the bottom row) is mainly used to display MP3 file names or CD text information. It is also used to display various messages, such as effects parameter settings and more. CD/MP3 ­ Indicates whether the current disc is a standard audio disc or an MP3 disc. SINGLE ­ Controlled by the CTN/SGL button, this indicates when the unit is set to play just one track at a time. When this is not illuminated, the CD will play continuously through all tracks. RELOOP ­ Indicates when there is a previously set loop, and that the loop is ready to be played again. HAND ­ Indicates when the touch sensitive surface of the jog wheel is active. WHEEL INDICATOR ­ This is a visual representation of a vinyl marker, which is traditionally used to mark the location of a certain sound or cue point on a vinyl record. Here, it indicates the play position, rotates during playback in either direction, and stops during cue or pause mode. It also indicates the speed of the forward and reverse search operation. ELAPSED / TOTAL / REMAIN ­ Indicates whether the time shown on the display refers to total remaining time or track remaining time. If either of these are not illuminated, this indicates elapsed track time. 7 SET UP Checking the contents Check that the carton contains all of the following items: · · · · · Tabletop CD player unit Printed user's manual One RCA cable One power cable One fader start / relay cable Installing the Unit · · · · Place the unit on a flat, level surface. Be sure the player is in a well-ventilated area where it will not be exposed to direct sunlight, high temperatures, or high humidity. Try to place the unit as far as possible from TVs and tuners, as the unit may cause undesirable interference. The player will work normally when the unit is within 15 degrees of the vertical plane. If the unit is tilted excessively, discs may not load or unload properly, or playback may be adversely affected. · The unit's LCD screen is designed to be clearly visible within the angles shown in the figure below. Place the unit so that the LCD screen is within this visual range for optimal clarity. CONNECTIONS · Make sure that the unit and any other equipment in the signal chain are turned off prior to making any connections. · Connect the RCA cable to the rear of the unit and to the input on your mixer. · Connect the power cable to the rear of the unit and to a proper AC outlet. · To avoid severe damage to the unit, besure the power is OFF when making any connections. 8 OPERATING INSTRUCTIONS UPDATING FIRMWARE Checking Firmware Version · Turn the unit off. · Hold down the MODE button (under SAMPLE SEQUENCER) while powering up the unit. [. . . ] · Power off the unit · Press and hold the CLEAR button as you power up the unit, · The display will read clearALL, release the CLEAR button WARNING: Restoring factory settings will delete cue point memory. FADER START By connecting the CD player to a mixing board that has the fader start feature, the crossfader will engage playback or cue mode depending on its location. If the CD player is connected to the left side of the crossfader, playback will start once the fader is moved from the left most position towards the right. The CD player will re-cue itself when the crossfader is brought back to the left most position. Two CD players can be hooked up in this fashion to work on both sides of the crossfader. 12 SPECIFICATIONS 1. [. . . ]