User manual STANTON M.202

[. . . ] Crossfader Start Function MIXER CONTENTS 4 2 6 11 10 14 9 3 1 12 13 5 15 7 8 MIXER CONTENTS 1. Input fader - Controls individual source levels (channels) in the mix. Input toggle switch - Selects which source will be active based on what you have connected to the rear panel input section (phono/line). [. . . ] When in the ON position, the fader start allows the fader to return automatically to preset digital CUE POINTS on your compatible STANTON DJ CD Player. Mic EQ ­ The mic channel include a two-band EQ with a range of +10dB to ­10dB. Level Indicators ­ The dual LEDs indicators are used to indicate the master output level of channels Right and Left. Always use this connection when using standard turntables with ground cable. (Some turntables like the T. 80 / T. 120 do not require grounding wire). When these connectors are used, your signal is fed directly to the high-quality RIAA phono pre-amplifiers. Line level sources will overload the sensitive phono pre-amps and will cause distortion. Line Inputs - Unbalanced RCA jacks for connecting stereo audio from line level sources such as CD players, HiFi VCRs, cassette decks, DAT machines, laser discs, tuners, even synthesizers or other mixing consoles. NOTE: Plug mono audio sources into both Left and Right inputs using a "Y" cable connector. Master Output - Unbalanced RCA connectors controlled by the Master level. Fader Start ­ This function works in conjunction with a compatible fader start CD player. When used with a compatible CD player, you can use the crossfader to start and stop the CD player with the slide of the fader. When in the ON position, the fader start allows the fader to return automatically to preset digital CUE POINTS on your compatible STANTON DJ CD Player. Note*** Remember to turn ALL volume levels down when turning on/off the unit. Power Connector - Plug in the included power supply here. QUICK SETUP DIAGRAM Study this setup diagram. Finally, connect the stereo outputs to the power amplifier(s) and/or audio receivers such as tape decks. IMPORTANT: Always switch on your audio input sources such as turntables or CD players first, then your mixer, and finally any amplifiers. When turning off, always reverse this operation by turning off amplifiers, then your mixer, and then input devices. SPECIFICATIONS INPUT / OUTPUT IMPEDANCE & SENSITIVITY: LINE -14dB/10K OHM ±2dB PHONO -50dB /47K OHM ±2dB MIC -60dB /2. 2K OHM ±2dB MASTER 1K OHM PHONES 0dB/33 OHM ±2dB (LOAD=32 OHM) MAX. [. . . ] Stanton's liability for any claim, whether based on breach of contract, negligence, infringement of any rights of any party, or product liability, and relating to the merchandise shall not exceed the price received by Stanton from your purchase of such merchandise. In no event will Stanton be liable for any special, incidental or consequential damages (including loss of use, loss of profit and claims of third parties) however caused, whether by the negligence of Stanton or otherwise. To the extent permitted by law and except as otherwise provided above, Stanton disclaims any express or implied warranties of merchantability or fitness for a particular purpose. [. . . ]