User manual STANTON M.303

[. . . ] · To avoid damage due to AC voltage peaks, always disconnect your mixer from the power source during electrical storms. The manufacturer is not responsible for any damage or personal injury resulting from unauthorized user-servicing or modifications. In addition, the warranty will be void if any unauthorized service by the user is detected. Always return your mixer to an authorized Stanton dealer for servicing. FA D E R C L E A N I N G A N D I N S TA L L After constant use the faders may need to be cleaned and lubricated from time to time. [. . . ] Crossfader - The crossfader is used to cross fade between channels 1 and 3. Kill switches - Kill switches are used to completely eliminate Hi, Mid, or Low frequencies from the audio. Headphone outputs - This is the headphone output jack to connect your headphones. Cue pan - Fades the headphone output between the PFL signal (selected by the Cue Select buttons) and master output, effectively allowing the user to preview a mix. It is usually used for monitoring in a DJ booth, but can be used for various applications. Master output Pan- This is the pan or balance control for the master output. Output meters - These LEDs let you know if the audio coming out of the mixer is loud enough (or too loud!). If the LEDs reach the red, the mixer is probably clipping, or distorting. Input selectors - These toggle switches select the input source between phono and line for each channel. An LED meter is provided on each of the 3 channels for proper adjustment of the levels. Channel equalizer - Individual controls for high frequency, midrange, and low frequency equalization with +9dB/Kill adjustments. Note: Any changes made to EQ settings will change the overall output level. DESCRIPTION OF FUNCTIONS Power: This is the power switch to turn the mixer "ON" or "OFF" AC IN: This is the Input connection for the included power supply. Line: Line inputs (represented by the letter L, followed by the input number) are used to connect to line level sources such as CD players, Mini Discs, DATs, samplers, etc. Ground: Connects to the turntable ground cable to eliminate electrical hum. Ground cables are usually supplied with turntables Master: Connects to an amplifier, EQ, crossover, or other outboard signal processing. It is usually used as a separate output in the DJ Booth for the DJ to monitor the mix REC: This is the record output. The output level is static in this case, there are no volume controls. The volume can be set from the recording device. SUPERIOR SOUND TECHNOLOGY The audio quality of the M. 303 is nothing short of revolutionary for DJ mixers in its price class. [. . . ] Any returns to a non-authorized dealer or to an authorized Stanton dealer not in the same country as the merchandise was intended to be sold or as set forth above will void this warranty. To initiate a warranty repair, you must contact the authorized Stanton dealer from whom you purchased the merchandise, and follow such authorized Stanton dealer's return policy. Stanton assumes no risk and shall be subject to no liability for damages or loss resulting from the specific use or application made of the merchandise. Stanton's liability for any claim, whether based on breach of contract, negligence, infringement of any rights of any party, or product liability, and relating to the merchandise shall not exceed the price received by Stanton from your purchase of such merchandise. [. . . ]