User manual STANTON RM-50

[. . . ] Again, we appreciate your patronage, and look forward to many years of making music together. Low frequency hum while operating source unit. Problem Excessive hum when using phono source. Cause Poor ground connection. Solution Properly connect turntable ground wire to mixer ground terminal. Properly set crossfader, channel faders, gain controls, and input selector toggles. [. . . ] In addition, the warranty will be void if any unauthorized service by the user is detected. Always return you mixer to an authorized Stanton dealer for servicing. Blown fuse. The amplifier is turned up, but there is no signal. Faulty output connections Improper level adjustment. No signal in headphones. Improper connection. Improper level or cue mix settings. D E S C R I P T I ON O F F U N C TI O N S players (such as Stanton's S-Series) to start the audio from the CD player's cue point. Mic selector: Turns the mic on or off and activates the automatic talkover circuit. When activated, the automatic talkover circuit reduces the music output based on the setting of the talkover attenuation control (19). Mic EQ: Individual controls for low frequency and high frequency equalization with (+10/-10 dB) for mics 1, 2, and 3. Note: Any changes made to EQ settings will change the overall output level. Microphone 1 and 2 inputs: Combo connector is for mic 1, and the 1/4" connector is for mic 2. Mono/stereo switch: switches the of Master output between a stereo and mono signal 4. Master balance control: Controls left/right signal balance of the master output. It is recommended headphones with an impedance rating of 200 ohms or less be used for maximum volume. Cue pan: Fades the headphone output between the channel(s) selected by the cue assign switches (17) and the master one output, effectively allowing the user to preview a mix. Master level control: Controls the overall signal output level of the master output. Equalizer: Individual controls for low frequency, midrange, and high frequency equalization with (+10/-10 dB) Note: Any changes made to EQ settings will change the overall output level. Crossfader source selectors: When set to A, the select channel will be assigned to the left side of the crossfader. when set to B, the selected channel will be assigned to the right side of the crossfader. Crossfader: Fades the master output between the channels selected by the Crossfader source selectors (13). Output Level meter: Displays the overall signal level of the master output. [. . . ] Replacement parts are available from Stanton or your local Stanton dealer. CF-RM19 LF-RM19 RF-RM19 PS-RM19US PS-RM19EU PS-RM19UK Crossfader Line input fader Line input rotary (dial) fader US Power Supply (110v) European Power Supply (220v) UK only Power Supply (240v) WA R R A N T Y This unit has been designed and manufactured using quality components. Therefore, it is warranted to be free from defects in materials (limited as specified below), and workmanship for a period of twelve (12) months from the original purchase date. During this period, all service and parts necessary to repair a defect will be free of charge. [. . . ]