User manual STANTON RM-THREE

[. . . ] Spray a small amount of cleaner or lubricant into both ends of the fader and slide the fader back and forth a few times to spread the fluid evenly throughout the fader. Shake and wipe off excess fluid before re-assembling the fader. RM THREE Professional performance mixer FA D E R R E PL AC E M E N T To replace the cross or channel faders, follow step 1 of the cleaning instructions. Replacement parts are available from Stanton or your local Stanton dealer. LF-RM3 CF-RM3 PS-18US PS-18EU PS-18UK Channel input fader Crossfader US Power Supply (110v) European Power Supply (220v) UK only Power Supply (240v) OWNER'S M A N U A L © 1999, Stanton Magnetics, LLC T RO U B LE S H O OT I N G Thank you for making Stanton your first choice in professional DJ mixers. [. . . ] Impact, or heavy vibration may compromise the unit's mechanical integrity. The manufacturer is not responsible for damage resulting from an impact, or misuse. · When in use, place your mixer away from sources of hum or noise, such as transformers, or electric motors. · To prevent overheating, always provide your mixer with adequate ventilation air space. · To avoid damage due to AC voltage peaks, always disconnect your mixer from the power source during electrical storms. The manufacturer is not responsible for any damage or personal injury resulting from unauthorized user-servicing or modifications. In addition, the warranty will be void if any unauthorized service by the user is detected. Always return you mixer to an authorized Stanton dealer for servicing. Blown fuse. The amplifier is turned up, but there is no signal. Faulty output connections Improper level adjustment. No signal in headphones. Improper connection. Improper level or cue mix settings. D E S C R I P T I O N O F FU N C TI O N S 1. Mic EQ: Controls for low frequency, midrange, and high frequency equalization of both microphones with (+/-12 dB) Note: Any changes made to EQ settings will change the overall microphone output level 5. Effect ON/OFF switches: Turns effect send signal ON or OFF for each channel 6. Input selector switches: Selects the audio signal source for each channel 8. EQ: Individual controls for low frequency, midrange, and high frequency equalization with (+9/-26 dB) Note: Any changes made to EQ settings will change the overall output level 10. Frequency Kill switches: Individual kill controls for low frequency, midrange, and high frequency of channels 1 and 3 14. It is recommended headphones with an impedance rating of 200 ohms or less be used for maximum volume 16. It is recommended headphones with an impedance rating of 200 ohms or less be used for maximum volume 17. Master balance control: Controls left/right output balance of the overall signal 20. Send level: Controls the level of the signal traveling to the external effects unit used in the effects loop 21. [. . . ] Power supply connector: Input connection for the accompanying power supply. WA R R A N T Y This unit has been designed and manufactured using quality components. Therefore, it is warranted to be free from defects in materials (limited as specified below), and workmanship for a period of twelve (12) months from the original purchase date. During this period, all service and parts necessary to repair a defect will be free of charge. [. . . ]