User manual STANTON S-350

[. . . ] PROFESSIONAL CD PLAYER IN OUT CUE TIME USERS MANUAL Important To Safety WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord. [. . . ] Key Correction mode allows tempo change while maintaining the original key. When the Key Correction is selected, the LED above the KEY CORRECTION button glows red. PITCH ON/OFF BUTTON This button is used to turn the PITCH SLIDER function on and off. 4%, 8%, 16%, 100% PITCH SELECT BUTTON Press the button in order to change pitch percentage of 4%, 8%, 16%, 100%. BANK BUTTONS Press the desired BANK button when the MEMORY LED is lit will set the memory mode. Press the desired BANK button when the SAMPLER LED is lit will set the sampler mode. The sampler length is determined by the smaller one of out point and bank length. Press the desired BANK button will return to the start point instantly. PITCH SLIDER This slider is used to adjust the playback pitch percentage. The slider is a set adjustment and will remain set until the pitch slider is move or the pitch function has been turned off. TIME BUTTON The TIME button will switch the time value described in the time meter between elapsed play time, track remaining time, and total remaining time. SGL/CTN BUTTON This function allows you to choose between single track play or continuous track play (all tracks in order). PITCH -/+ BUTTONS The desired pitch of CD decrease or increase when button is pressing and returns to the original pitch when the button is released. MINUTE, SECOND, FRAME Displays the time of track(s) currently selected in increments of Minutes, Seconds, and Frames. TIME BAR Shows either time remaining or elapsed depending on the setting of the TIME button. ANTI SHOCK AND BUFFER INDICATOR Indicates the current status of the Buffer Memory. This is represented on the display by a bucket being filled or emptied. The bucket itself represents the instant start function (which works by buffer memory). Each bar within the bucket represents 2 seconds of anti shock protection. WHEEL INDICATOR A visual representation of a vinyl marker, indicating play position in frames. This wheel rotates during playback and stops during pause and also indicates direction (fwd/rev). Set-up 1. Checking the Contents Check the carton and packaging contents for the following items: 1. Be sure the player is in a well-ventilated area where it will not be exposed to direct sunlight, high temperatures, or high humidity. [. . . ] 16. Recall Cue Point w Press the MEMORY button to make the unit enter cue recall mode (LED off), then press the desired BANK button to recall the desired cue memory point, during playback or pause mode accessing a stored cue point will cue to that point and instantly start without any music interruption. The last cue that was stored or recalled will flash in the LCD screen to let you know it was last cued 17. Memory Backup This will automatically keep your last setting (SGL, CTN) even if you unplug AC current. 18. Fader Start Playback Both player's CONTROL jack are connected to Mixer's CROSS FADER signal output CH1 or CH2; when the jack are connected, the operation for both player as following: Left player will return to standby mode at CUE point automatically when move CROSS FADER from left to right to start playback on right player. Right player will return to standby mode at CUE point automatically when move CROSS FADER from right to left to start playback on left player. [. . . ]