User manual STANTON S-550

[. . . ] USER MANUAL REMAIN CONTINU TRACK M S F TRACK M S F REMAIN CONTINU PROFESSIONAL DUAL CD PLAYER IMPORTANT TO SAFETY IMPORTANT TO SAFETY WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord. [. . . ] When you release the CUE button it instantly returns to the CUE POINT. Press once to start playback, once again to set the pause mode, and once more to resume playback. (19)IN This allows you to set the cue point without stopping the play back. The player will start to loop continues until you press this button again to exit. (21)PITCH (Pitch Button) Press PITCH button to switch on/off pitch. ; hold the PITCH button down for more than 0. 6 sec to switch pitch in +/-8% / +/-12% / +/-16%. (22)CONTROL CONNECTOR Connect this connector to the REMOTE connector on the main unit using the included control cord. (23)CONTROL SOCKET Via the Control socket, the respective CD-player can be remotely controlled. If you are using a mixer with fader start-function connect the player with the Control Out-socket. Please note that these sockets must never be connected with any voltage. LCD (24) ~(27)TRACK, MINUTE, SECOND and FRAME Displays These displays indicate information for the CD's current position and time. (28) BAR Indicator These ten indicators provide a visual display of the approximate position of the pickup within the current track. (29) ELAPSED Indicator It indicates that the time shown for the display is the elapsed time. (30) CONTINU Indicator When the indicator lights, the function will cause the unit to play continuously. (31) SINGLE Indicator When the indicator lights, playback will stop at the beginning of the next track. (32) REMAIN Indicator It indicates that the time shown on the display is the remaining time of playing track. (33) PITCH DISPLAY It shows the BPM change range, the BPM changes within a range of +/-12%. 6 OPERATIONS 1. OPEN/CLOSE buttons are provided on both the main unit and control unit. The disc holder cannot be opened during playback to prevent playback from being interrupted if the OPEN/CLOSE button is pressed accidentally. Loading discs Hold the disc by the edges and place it in the disc holder, then press the OPEN/CLOSE button again to close the disc holder. The unit will show the total track number and the total playing time for about 2 seconds then enter the cue condition, the cue point will be set to the music starting point of the first track automatically. Figure 2-1 CAUTION: Do not place any foreign objects in the disc holder, and do not place more than one disc in the disc holder at a time. Do not push the disc holder in manually when the power is off, as this may result in malfunction and damages the player. 3. Selecting Tracks Press the SKIP button once to move to next higher or lower track. When a new track is selected during playback, playback begins as soon as the skip search operation is completed. [. . . ] Do not use benzene, thinner, water, record spray, electrostatic-proof chemicals, or silicone-treated cloths to clean discs. Always handle discs carefully to prevent damaging the surface; in particular when removing a disc from its case or returning it. Do not write on the label (printed side) with a hardtipped implement such as a pencil or ball point pen. Condensation will form if a disc is brought into a warm area from a colder one, such as outdoors in winter. [. . . ]