User manual STANTON S-650

[. . . ] REMAIN CONTINU TRACK M S F TRACK M S F REMAIN CONTINU PROFESSIONAL DUAL CD PLAYER IMPORTANT TO SAFETY WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord. [. . . ] (28) BAR Indicator These ten indicators provide a visual display of the approximate position of the pickup within the current track. (29) ELAPSED Indicator It indicates that the time shown for the display is the elapsed time. (30) CONTINU Indicator When the indicator lights, the function will cause the unit to play continuously. (31) SINGLE Indicator When the indicator lights, playback will stop at the beginning of the next track. (32) REMAIN Indicator It indicates that the time shown on the display is the remaining time of playing track. (33) PITCH DISPLAY Shows the current percentage of pitch change, pitch range is selectable from +/-8%, 12%, or 16%. PREPARATIONS 1. Checking the Contents Check that the carton contains the following items: 1) Main unit 2) Control unit 3) Operating instruction 4) Pair of RCA pin cord. Installing the Unit Mount the unit into your console or rack with 19" EIA rack rails. CAUTION: The player will work normally when the main unit is mounted with the front panel at within 15 degrees of the vertical plane. If the unit is tilted excessively, discs may not be loaded or unloaded properly. 15 The control panel's LCD's are designed to be clearly visible within the angles shown in Figure 2. Mount the control unit so that the visual angle is within this range. 45 5 Main unit Control panel Button . Figure 1 Figure 2 Connections 1) Turn off the POWER switch. 3) Connect the control cords to the REMOTE connector on the main unit. OPEN/CLOSE buttons are provided on both the main unit and control unit. The disc holder cannot be opened during playback to prevent playback from being interrupted if the OPEN/CLOSE button is pressed accidentally. Loading discs Hold the disc by the edges and place it in the disc holder, then press the OPEN/CLOSE button again to close the disc holder. The unit will show the total track number and the total playing time for about 2 seconds then enter the cue condition, the cue point will be set to the music starting point of the first track automatically. Figure 2-1 CAUTION: Do not place any foreign objects in the disc holder, and do not place more than one disc in the disc holder at a time. Do not push the disc holder in manually when the power is off, as this may result in malfunction and damages the player. 3. Selecting Tracks Press the SKIP button once to move to next higher or lower track. When a new track is selected during playback, playback begins as soon as the skip search operation is completed. If the skip button is pressed while at the last track, the first track is selected. In the same way, if the skip button is pressed while at the first track, the last track is selected. 4. Starting Playback Press the PLAY/PAUSE button during the pause or cue to start playback, the PLAY indicator lights when playback starts. Figure 4-1 5. [. . . ] Always handle discs carefully to prevent damaging the surface; in particular when removing a disc from its case or returning it. Do not write on the label (printed side) with a hardtipped implement such as a pencil or ball point pen. Condensation will form if a disc is brought into a warm area from a colder one, such as outdoors in winter. Precaution on storage After playing a disc, always unload it from the player. [. . . ]