User manual STANTON S-650 MK II

[. . . ] S-650 MK II TRACK M S F TRACK M S F S-650 MK II S-650 MK II IMPORTANT TO SAFETY WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. Handle the power supply cord carefully Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord. [. . . ] (6) PROG (Program Button) Press the PROGRAM button, the player will enter the program mode and stop the CD playback. (7) PROGRAM Indicator The PROGRAM LED lights when program mode is set. (8) RELOOP If a seamless Loop has been made, but the CD Player is not actively in Seamless Loop mode, press the RELOOP button to reactivate the Seamless loop mode. (9) PITCH Indicator When the indicator lights, the pitch adjustment is enabled. 4 NAMES AND FUNCTIONS (10)Pitch Slider Use the slider to adjust the CD pitch. (11)JOG (Jog Dial) During PLAY, the jog dial is used temporarily bending the pitch (pitch bend). When CD is paused, the jog dial is used for frame search each segment of the dial represents a frame. SKIP Use these buttons to go back to the beginning of the current track or select a previous track for playing. (14)CUE (Cue Button) Pressing the CUE button during play provides a return to the position at which play was started. (30) CONTINU Indicator When the indicator lights, the function will cause the unit to play continuously. (31) SINGLE Indicator When the indicator lights, playback will stop at the beginning of the next track. (32) REMAIN Indicator It indicates that the time shown on the display is the remaining time of playing track. (33) PITCH DISPLAY Shows the current percentage of pitch change, pitch range is selectable from +/-8%, 12%, or 16%. 24 25 26 27 28 29 30 31 32 33 (24) ~(27)TRACK, MINUTE, SECOND and FRAME Display These displays indicate information for the CD's current position and time. (28) BAR Indicator These ten indicators provide a visual display of the approximate position of the pickup within the current track. PREPARATIONS 1. Checking the Contents Check that the carton contains the following items: 1) Main unit 2) Control unit 3) Operating instruction 4) Pair of RCA pin cord. Installing the Unit Mount the unit into your console or rack with 19" EIA rack rails. CAUTION: The player will work normally when the main unit is mounted with the front panel at within 15 degrees of the vertical plane. If the unit is tilted excessively, discs may not be loaded or unloaded properly. 15 The control panel's LCD's are designed to be clearly visible within the angles shown in Figure 2. Mount the control unit so that the visual angle is within this range. 45 5 Main unit Control panel Button . Figure 1 Figure 2 Connections 1) Turn off the POWER switch. 3) Connect the control cords to the REMOTE connector on the main unit. OPEN/CLOSE buttons are provided on both the main unit and control unit. The disc holder cannot be opened during playback to prevent playback from being interrupted if the OPEN/CLOSE button is pressed accidentally. [. . . ] When the currently playing track ends, playback will begin automatically on the standby player. The first player will enter standby mode at the beginning of the next track on its disc. By repeating this operation, the two players can be used to perform continuous relay play. By loading new discs on the standby player, you can construct a continuous program of whatever tracks you wish. [. . . ]