User manual STANTON SA.5

[. . . ] · When in use, place your mixer on a stable surface, away from vibration. Impact, or heavy vibration may compromise the unit's mechanical integrity. The manufacturer is not responsible for damage resulting from an impact, or misuse. · When in use, place your mixer away from sources of hum or noise, such as transformers, or electric motors. [. . . ] Balanced Master output: TRS balanced (1/4") connectors are typically used to connect to a P. A. mixer or an amplifier for live performances or a recording console for recording. Unbalanced Master output: RCA connectors are typically used to connect to a home stereo or to another mixer with RCA inputs for practicing or team routines. Several SA. 5's can be daisy chained from this output via the session input (25). It can be used to record to a computer, CD, MD, & tape recorder, even while the master volume is turned down. Ground connector: Connects to the turntable ground connector to eliminate electrical hum. Some newer turntables such as the Stanton STR8. 150 do not require a ground cable because they are grounded internally. Session Input: This extra line level input is controlled by the session level fader (1) when the Session/Mic switch (27) is switched to session (the up position). It can be used as an extra line input or as a session input for team routines. B A C K PA N E L 28. Session/Mic switch: Used to assign the Session/Mic fader to either the Session input or the MIC input. Line inputs: Line level inputs for channels 1 and 2. F R O N T PA N E L 34 34 34 33 35 36 35 37 33. Headphone output: Standard 1/8" (mini jack) headphone output connector. Reverse indicator LEDs: The LEDs indicate the status of the fader reverse functions. Line fader curve switch: Three-position switch selects between a sharp, mid and long fade for the corresponding line fader. Cross fader curve switch: Three-position switch selects between a sharp, mid and long fade for the crossfader. Headphone output: Standard 1/4" headphone output connector. FA D E R C L E A N I N G A N D R E P L A C E M E N T After constant scratching, the SA. 5 faders may need to be cleaned and lubricated from time to time. This will ensure long life and keep a smooth feeling throughout the fader's lifetime. Follow the instructions below to lubricate and clean your faders: REMOVING A FADER: 1. Make sure mixer is powered off and power supply is disconnected from the back of the mixer. To remove the lower faceplate, take off all the fader knobs and then remove the 4 screws located on the sides of the mixer (2 on each side). Remove the fader to be cleaned or replaced by unscrewing the 2 outer screws on the fader plate (removing the 2 inner screws will detach the fader from the fader plate). Disconnect the fader from the mixer by removing the connector on the bottom of the fader. [. . . ] Any returns to a non-authorized dealer or to an authorized Stanton dealer not in the same country as the merchandise was intended to be sold or as set forth above will void this warranty. To initiate a warranty repair, you must contact the authorized Stanton dealer from whom you purchased the merchandise, and follow such authorized Stanton dealer's return policy. Stanton assumes no risk and shall be subject to no liability for damages or loss resulting from the specific use or application made of the merchandise. Stanton's liability for any claim, whether based on breach of contract, negligence, infringement of any rights of any party, or product liability, and relating to the merchandise shall not exceed the price received by Stanton from your purchase of such merchandise. [. . . ]