User manual STANTON SMX301

[. . . ] This limited warranty applies to mechanical parts which are subject to wear and tear as specified: · Faders (except P&G fader), specified durability: 15, 000 cycles; · Rotary potentiometers, specified durability: 10, 000 cycles; · Switches, specified durability: 10, 000 cycles. Consequently, the parts listed above are warranted to be free from defects in materials and workmanship for a period of thirty days (30) days from the original purchase date. For the warranty to be valid, please complete the warranty registration card attached or fill out the online registration at: www. stantondj. com Mail completed warranty cards to: Stanton Magnetics, Inc, 3000 SW 42nd · Hollywood, FL 33312 SMX-301 PROFESSIONAL DJ MIXER OWNER'S M A N U A L R E P L A C E M E N T PA RT S The following user replaceable parts are available from your local Stanton dealer. LF301 CF301 PS-16US PS-16EU PS-16UK Line fader Crossfader US Power Supply (110v) European Power Supply (220v) UK only Power Supply (240v) © 2003, Stanton Magnetics, Inc. STANTON MAGNETICS, INC info@stantonmagnetics. com · (954) 689-8833 www. stantondj. com WELCOME! Thank you for making Stanton your first choice in professional DJ mixers. [. . . ] · To avoid damage due to AC voltage peaks, always disconnect your mixer from the power source during electrical storms. The manufacturer is not responsible for any damage or personal injury resulting from unauthorized user-servicing or modifications. In addition, the warranty will be void if any unauthorized service by the user is detected. Always return your mixer to an authorized Stanton dealer for servicing. DESCRIPTION OF FUNCTIONS FADER CLEANING AND INSTALL After constant use the SMX-301 faders may need to be cleaned and lubricated from time to time. This will ensure long life and keep a smooth feeling throughout the fader's lifetime. Follow the instructions below to lubricate and clean your faders: Removing a fader: 1. Make sure mixer is powered off and power supply is disconnected from back of mixer. Remove the fader to be cleaned or replaced by unscrewing the 2 outer screws on the fader plate (removing the 2 inner screws will detach the fader from the fader plate). Disconnect the fader from mixer by removing the connector on the bottom of the fader. Once original fader has been removed, simply plug the 4-pin connector into the new fader. Place fader back in mixer and replace 2 outer screws to secure fader. Power: This is the power switch to turn the mixer "ON" or "OFF" AC IN: This is the Input connection for the included power supply. Line: Line inputs (represented by the letter L, followed by the input number) are used to connect to line level sources such as CD players, Mini Discs, DATs, samplers, etc. Ground: Connects to the turntable ground cable to eliminate electrical hum. Ground cables are usually supplied with turntables Master: Connects to an amplifier, EQ, crossover, or other outboard signal processing. It is usually used as a separate output in the DJ Booth for the DJ to monitor the mix REC: This is the record output. The output level is static in this case, there are no volume controls. The volume can be set from the recording device. DESCRIPTION OF FUNCTIONS DESCRIPTION OF FUNCTIONS 1. Microphone 1 input - This combo (1/4"/XLR) connector is used to connect a microphone. [. . . ] Output meters - These LEDs let you know if the audio coming out of the mixer is loud enough (or too loud!). If the LEDs reach the red, the mixer is probably clipping, or distorting. Input selectors - These toggle switches select the input source between phono and line for each channel. An LED meter is provided on each of the 3 channels for proper adjustment of the levels. [. . . ]