User manual STANTON ST-100

[. . . ] ASSEMBLY Please check to make sure the following items are included with the main unit in the carton: (1) Operating instructions (2) Platter (3) Slip mat (4) Counterweignt (5) 45 rpm adaptor (6) AC cord (7) Connecting cord FEATURES 1. High torque brush less DC motor This set uses a high torque brushless DC motor to reach the normal speed of Rotation rapidly and reduce braking time. +/-8%, +/-16%, +/-25% pitch control The pitch can be changed in a range of +/-8%, +/-16%, +/-25% using the pitch slider. A pitch On/off button lets you return to the normal speed of rotation at the touch of a button. [. . . ] 7 Key correction Press to enable key correction the light will turn on and the key won=t change when adjusting the pitch slider. 9 Reverse Press this button to switch the reverse and forward playback. 10 Headshell The cartridge has been pre-mounted on the headshell. 3 5 6 HT HEIG AD T JUS 16 0 14 8 13 23 When installing a cartridge, refer to the installation instructions supplied by the manufacturer of that cartridge. During installation, attach the stylus protector to guard the stylus tip from damage. 11 Pitch slider Use this to change the speed of the platter when the PITCH button is lit. 12 Headshell locking nut Attach headshell by inserting into the front end of the tone arm, then turn the locking nut clockwise with the head shell firmly held horizontally. 13 Tonearm 14 Tone arm clamp and rest Use this rest the tone arm and clamp it in position during transportation. 16 Counterweight Use this to balance the tone arm and to adjust the stylus pressure. 19 Output terminal (DIGITAL OUTPUT) Use this output to connect your ST-100 to a digital device such as a CD-R or Computer. 20 Line / Phono selector 21 Line out 22 Power switch 23 Mp3 Line in 4 OPERATION Starting playback 1Switch the power dial to turn on. 4Set the speed button's according to the record's playing speed. 6Hold the head shell's finger support, and move the tone arm to the desired position over the record. 7Lower the tone arm gently until the stylus is on the record and playback begins. 8Adjust the speed of rotation. When pitch is on, the speed of the platter can be adjusted in a range of +/-8%, +/-16%, +/-25% by the pitch slider. [. . . ] 2-2Connect the RCA cord of step 1 into the digital input jack of a "Digital Processor" or "MD Recorder". 2-3Connect the connector side of the power cord to the set=s power connector terminal (AC IN). Check that the power outlet=s capacity is sufficient. SPECIFICATION Power supply: AC 115/230v, 50/60Hz: Power consumption: 15W Dimensions: 450(W) x 352(D) x 148(H)mm Weight: 9. 5Kg Motor: 8pole, 3phase, brushless DC motor Starting Torque: More than 1. 6 kgf. cm Platter: 330mm dia. Aluminun diecast Pitch: +/-12%, +/-8% Brake: Electronic brake Wow & Flutter: Less than 0. 20% WRMS (JIS WTD) with 331/3rpm S/N ratio: More than 50dB (DIN-B) Channel Separation: More than 15 dB 6 [. . . ]