User manual STANTON STR880

[. . . ] Grounding or Polarization ­ This product may be equipped with a polarized alternation-current line plug (a plug having one blade wider than the other). If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Power-Cord Protection ­ Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to the cord in correspondence of plugs, convenience receptacles, and the point where they exit from the appliance. [. . . ] All other servicing should be referred to qualified service personnel. Ventilation ­ Slots and openings in the cabinet are provided for ventilation and to ensure reliable operation of the product and to protect it from overheating, and these openings must not be blocked or covered. The openings should never be blocked by placing the product on a bed, sofa, rug, or other similar surface. This product should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is the manufacturer's instructions have been adhered to. Attachments ­ do not use attachments not recommended by the product manufacturer as they may cause hazards. Accessories ­ Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer, or sold with the product. Any mounting of the product should follow the manufacturer's instructions, and should use a mounting accessory recommended by the manufacturer. IMPORTANT SAFETY INSTRUCTIONS 21. Lightning ­ For added protection for this product during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the antenna or cable system. This will prevent damage to the product due to lightning and power-line surges. 2) STROBE DOTS The dots around the edge of the platter are used in conjunction with the light located inside the motor ON/OFF switch. While the platter is in rotation, the dots help to indicate the speed of rotation. The speed is lower than the displayed speed (33, 45, 78) when the dots are flowing to the right. It is higher than the displayed speed (33, 45, 78) when the dots are flowing to the left. When the strobe is stopped, the platter is rotating at the displayed speed. 3) MOTOR ON/OFF SWITCH As opposed to fully analog turntables, this is not the power switch. The platter will not start spinning until the start/stop button has been pressed. Rotate counter-clockwise during playback (off position) for a slow winding down effect. 4) PLATTER REVOLUTION SPEEDS (rpm) 33 rpm - Press 33 45 rpm - Press 45 78 rpm - Press 33 and 45 buttons simultaneously. 5) TARGET LIGHT Insert target light to the deck and it will light up. 5 6 7 8 9 10 6) START The Start time is adjustable from 0. 2~6 sec. 8) REVERSE This button is used to reverse the direction of the platter rotation. [. . . ] Aluminum diecast Pitch: +/-8%, +/-25%, +/-50% Brake: Electronic brake TONE ARM SECTION Tone arm type Effective Arm Length Tracking Force Adjust Range Applicable Cartridge Weight Frequency Response Channel Separation Channel Balance Wow & Flutter: S/N ratio: Needle Pressure range GENERAL SPECIFICATIONS Dimensions: Weight: Power supply: Static balanced straight shaped tone arm with cardanís suspension 194mm 0-3g 13-18g 20 - 20 KHz More than 15 dB Within 2. 5dB at 1 KHz Less than 0. 1% WRMS (JIS WTD) with 33 1/3rpm More than 60dB (DIN-B) 2-5g Power consumption: 450(W) x 353 (D) x 146 (H)mm 16. 4Kg AC 100V, 50Hz (For Japan) AC 110V, 60Hz (For Taiwan) AC 120V, 60Hz (For U. S. A. , Canada) AC 127V, 60Hz (For Mexico) AC 220V, 50Hz (For United Arab Emirates, Chile, Aegentina) AC 220V, 60Hz (For Philippines) AC 230V, 50Hz (For Europe, U. K. , New Zealand, South Africa, Singapore, Israel) AC 240V, 50Hz (For Australia) 14W Stanton Magnetics, Inc. ­ Warranty Provision ­ Returns for Repairs or Replacement WARRANTY Through Stanton's authorized dealers around the World, Stanton, or one of Stanton's authorized distributors outside the U. S. , will, without charge, repair or replace, at the sole discretion of the entity responsible for making the repair or providing the replacement, any Stanton merchandise proved defective in material or workmanship for a period of one (1) year (three (3) years for C. D. Exceptions to this warranty are as noted below: The warranty for mechanical parts which are subject to wear and tear are limited to the earlier to occur of thirty (30) days following the date of original purchase or the following number of cycles: Faders - 15, 000; Rotary potentiometers - 10, 000; and Switches - 10, 000. Stanton will warrant all replacement parts and repairs for ninety (90) days from the date of original shipment. [. . . ]