User manual SUNBEAM 2631-33

[. . . ] If the product is no longer available, replacement may be made with a similar product of equal or greater value. Do NOT attempt to repair or adjust any electrical or mechanical functions on this product. This warranty is valid for the original retail purchaser from the date of initial retail purchase and is not transferable. JCS dealers, service centers, or retail stores selling JCS products do not have the right to alter, modify or any way change the terms and conditions of this warranty. [. . . ] When using electrical appliances, basic safety precautions should always be followed including the following: Do not fill water reservoir beyond maximum fill level. WARNING: To prevent the risk of burns, be careful when filling a hot iron with water. Fix strap over iron and button or loop strap over clothes bar and button securely. ⷠTo protect against risk of electric shock, do not immerse the iron in water or other liquids. ⷠThe Steam Switch should always be turned OFF before plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect. ⷠAlways disconnect iron from electrical outlet when filling with water or emptying and when not in use. ⷠDo not operate iron with a damaged cord or if the iron has been dropped or damaged. Take it to an authorized service center for examination and/or repair. Incorrect reassembly can cause a risk of electric shock when the iron is used. ⷠClose supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while plugged in or turned on or on an ironing board. ⷠBurns can occur from touching hot metal parts, hot water or steam. Use caution when you turn a steam iron upside down ­ there may be hot water in the reservoir. ⷠIf the iron is not operating normally, disconnect from the power supply and have the iron serviced by an authorized service center. Do not set the iron on an unprotected surface, even if it is on its heel rest. While the iron is heating, make sure it is sitting on its heel rest on a stable, protected surface. TO CLEAN THE SOLEPLATE: Turn off and allow the iron to cool and then wipe it with a soft, damp cloth. [. . . ] If you do not use your iron on a daily basis, empty the water reservoir after each use for a longer iron life. To do so, unplug the iron, turn the iron upside down, open the fill hole cover, and allow water to flow from the fill hole. Loosely loop the power cord around the iron body and store the iron on its heel rest. Important: Wrapping the cord around the iron too tightly can damage the cord. [. . . ]