User manual SUNBEAM 3061

[. . . ] Except to the extent prohibited by applicable law, any implied warranty or condition of merchantability or fitness for a particular purpose is limited in duration to the duration of the above warranty. jCS disclaims all other warranties , conditions or representations , express , implied , statutory or otherwise. JCS shall not be liable for any damages of any kind resulting from the purchase, use or misuse of, or inability to use the product including incidental, special, consequential or similar damages or loss of profits, or for any breach of contract, fundamental or otherwise, or for any claim brought against purchaser by any other party. Some provinces, states or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusion may not apply to you. [. . . ] Iron garment inside out or use an ironing cloth* to prevent shine marks (especially on dark fabrics). Iron garment inside out or use an ironing cloth* and then brush the garment with your hand to raise the texture of the fabric. Mainly dry iron; steam may be used under garment manufacturer's instructions. Always read garment labels and follow the manufacturer's ironing instructions. , silks and synthetics) to avoid damaging them with an iron that is too hot. ⷠIf you are unsure of the fabric content of the garment, test a small area, such as a seam or facing, before ironing a visible area. Start with a low temperature and gradually increase the heat to find the best setting. ⷠWhen changing the temperature from a high setting to a low setting, allow approximately 5 minutes for the lower temperature to be reached. ⷠWhen steam ironing, use long, slow passes over the fabric. This will allow the steam to penetrate the fabric while allowing the heat of the soleplate to dry out the moisture. Be careful not to use an iron that is too hot because the lining may melt or stick to the soleplate. ⷠTo iron zippers, use an ironing cloth or make sure the zipper is closed and iron over the flap. Use the Ironing Guide to select the best setting and method for the fabric you plan to iron. ⷠSUNBEAM® irons are designed to be used with ordinary tap water. In areas where hard water exists, Sunbeam recommends running one to two iron water tanks full of distilled water every month. Using distilled water on a monthly basis will help to prevent mineral build up. In a vertical position (on its heel rest) without moving it, the iron will automatically turn off after 15 minutes. The Power Indicator will blink to let you know that the iron has stopped heating. WARNING: To prevent the risk of burns, be careful when filling a hot iron with water. WARNING: THE MOTION SMART® Auto-Off is a safety feature, not a recommended means for turning your iron off. See "Caring for Your Iron After Use" for information on turning off your iron and storing it , safely between use. While the iron is heating, make sure it is sitting on its heel rest on a stable, protected surface. [. . . ] WARNING: DO NOT steam garments while wearing them; this may result in injuries. You should use the Self-Cleaning feature once a month to maintain the optimal performance of your iron. Move the Steam Lever back and forth from /Off (Dry) several times to remove debris and minerals from the Steam Valve. Plug the iron into a power outlet and allow the iron to heat for 2 minutes. [. . . ]